Re: [PATCH v3] watchdog: Add watchdog timer support for the WinSystems EBC-C384

[William Breathitt Gray]

On Tue, Jan 26, 2016 at 09:02:45PM -0800, Guenter Roeck wrote:
>> Unfortunately, the sensors-detect only reported "No" for each Super I/O
>> chip test, while the superiotool gave an unhelpful "No Super I/O chip
>> detected" message.
>>
>
>Too bad. That suggests that the watchdog may in fact be implemented in the fpga.

I received a response from WinSystems: the watchdog timer is implemented
in the Lattice FPGA (base address 0x298), along with other WinSystems
firmware. I was offered two methods of identifying the chip.

The first method is to use a 16-bit read of the register at port address
0x29E to get the version number of the watchdog timer; my machine
reported a value of 0x0009. Unfortunately, I don't believe this method
is very reliable since the version number may not be consistent across
these motherboards, and the same value could easily happen to be
returned by an unknown hardware.

The second method is slightly more involved so I'll quote WinSystems:

> 8-bit read of 299h â save this value
> 8-bit write of 60h to 299h
> 16-bit read of 29ah should return the base address of the WDT which is 564h
> 8-bit write of saved value to 299h - donât want t accidentally change the WDT base address

If the system does return a value of 0x564, then it's pretty safe to say
that the watchdog timer is implemented on the chip. However, I'm not
sure it would be safe to send write commands to a port address until the
hardware has been identified; this second method may not be the best
route either.

What do you think?

William Breathitt Gray