Re: [PATCH v3 07/52] mtd: nand: core: use mtd_ooblayout_xxx() helpers where appropriate

[Harvey Hunt]

Hi Boris,

On 26/02/16 15:10, Boris Brezillon wrote:
> Hi Harvey,
>
> On Fri, 26 Feb 2016 14:35:08 +0000
> Harvey Hunt <harvey.hunt@xxxxxxxxxx> wrote:
>
> > [...]
> > I'll look into this more later today, but wanted to run it by you in
> > case you have any thoughts.
>
> Can you apply this patch [1], and let me know if you see the additional
> trace?

I applied the patch, the following is the (unchanged) output:

[    0.256375] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0x88
[    0.262887] nand: Micron MT29F64G08CBAAAWP
[    0.266995] nand: 8192 MiB, MLC, erase size: 2048 KiB, page size: 
8192, OOB size: 448
[    0.274881] jz4780-nand 1b000000.nand-controller: using hardware BCH 
(strength 24, size 1024, bytes 42)
[    0.289046] Bad block table not found for chip 0
[    0.297769] Bad block table not found for chip 0
[    0.302425] Scanning device for bad blocks
[    0.320239] Bad eraseblock 90 at 0x00000b400000
[    0.324934] Bad eraseblock 91 at 0x00000b600000
[    0.931054] Bad eraseblock 4092 at 0x0001ff800000
[    0.935917] Bad eraseblock 4093 at 0x0001ffa00000
[    0.944660] nand_bbt: error while writing bad block table -34
[    0.950448] jz4780-nand: probe of 1b000000.nand-controller failed 
with error -34
[    0.958079] UBI error: cannot open mtd 3, error -19
[    0.962788] UBI error: cannot open mtd 4, error -19[    0.970229] 
clk: Not disabling unused clocks

> Thanks,
>
> Boris
>
> [1]http://code.bulix.org/l2hkl1-91947

Thanks,

Harvey