Re: [PATCH v2 05/11] dt-bindings: Add bindings for phy-da8xx-usb

[Rob Herring]

On Wed, Mar 16, 2016 at 09:26:38PM -0500, David Lechner wrote:
> Device tree binding for new phy-da8xx-usb driver.
> 
> Signed-off-by: David Lechner <david@xxxxxxxxxxxxxx>
> ---
> 
> v2 changes: This is new patch in v2.
> 
> 
>  .../devicetree/bindings/phy/phy-da8xx-usb.txt      | 34 ++++++++++++++++++++++
>  1 file changed, 34 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/phy/phy-da8xx-usb.txt
> 
> diff --git a/Documentation/devicetree/bindings/phy/phy-da8xx-usb.txt b/Documentation/devicetree/bindings/phy/phy-da8xx-usb.txt
> new file mode 100644
> index 0000000..ed6b710
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/phy/phy-da8xx-usb.txt
> @@ -0,0 +1,34 @@
> +TI DaVinci DA8XX USB PHY
> +
> +Required properties:
> + - compatible: must be "ti,da830-usbphy".
> + - #phy-cells: must be 1.
> + - reg : Address and length of the CFGCHIP2 register.
> +
> +This device controls the PHY for both the USB 1.1 OHCI and USB 2.0 OTG
> +controllers on DA8XX SoCs. Consumers of this device should use index 1 for

DA8xx

> +the USB 1.1 phy device and index 2 for the USB 2.0 phy device.
> +
> +Example:
> +
> +	usbphy: usbphy@1c14184 {

TI has been doing the unit addresses wrong I've recently found. It 
should match the reg property, not be the full physical address. Please 
fix all these in the example.

> +		compatible = "ti,da830-usbphy";
> +		#phy-cells = <1>;
> +		reg = <0x14184 4>;
> +	};
> +
> +	usb11: usb11@1e25000 {

usb@...

> +		compatible = "ti,da830-ohci";
> +		reg = <0x225000 0x1000>;
> +		interrupts = <59>;
> +		phys = <&usbphy 1>;
> +		phy-names = "usbphy";
> +	};
> +
> +	usb20: usb@1e00000 {
> +		compatible = "ti,da830-musb";
> +		reg = <0x200000 0x1000>;
> +		interrupts = <58>;
> +		phys = <&usbphy 2>;
> +		phy-names = "usbphy";
> +	};
> -- 
> 1.9.1
>