Re: [PATCH] regulator: qcom_spmi: Add slewing delays for all SMPS types

[Stephen Boyd]

Quoting Georgi Djakov (2016-03-30 07:36:11)
> On 03/30/2016 01:58 AM, Stephen Boyd wrote:
> > Only the FT SMPS type regulators have slewing supported in the
> > driver, but all types of SMPS regulators need the same support.
> > The only difference is that some SMPS regulators don't have a
> > step size and the step delay is typically 20, not 8. Luckily, the
> > step size reads as 0 for the non-FT types, so we can always read
> > that, but we need to detect which type of regulator we're using
> > to figure out what step delay to use. Make these minor
> > adjustments to the slew rate calculations and add support for the
> > delay function to the appropriate regulator ops.
> > 
> > Reported-by: Georgi Djakov <georgi.djakov@xxxxxxxxxx>
> > Cc: David Collins <collinsd@xxxxxxxxxxxxxx>
> > Signed-off-by: Stephen Boyd <stephen.boyd@xxxxxxxxxx>
> 
> Thanks for the patch! I have verified it by applying this one
> on top: https://lkml.org/lkml/2016/3/30/381
> 
> Tested-by: Georgi Djakov <georgi.djakov@xxxxxxxxxx>
> 

Thanks for testing. I'll pick up the rest on the other thread.