[PATCH 3/3] irqchip: mips-gic: Setup EIC mode on each CPU if it's in use

[Paul Burton]

When EIC mode is in use (cpu_has_veic is true) enable it on each CPU
during GIC initialisation. Otherwise there may be a mismatch between the
hardware default interrupt model & that expected by the kernel.

Signed-off-by: Paul Burton <paul.burton@xxxxxxxxxx>
---

 drivers/irqchip/irq-mips-gic.c | 10 +++++++++-
 1 file changed, 9 insertions(+), 1 deletion(-)

diff --git a/drivers/irqchip/irq-mips-gic.c b/drivers/irqchip/irq-mips-gic.c
index 4dffccf..bc23c92 100644
--- a/drivers/irqchip/irq-mips-gic.c
+++ b/drivers/irqchip/irq-mips-gic.c
@@ -956,7 +956,7 @@ static void __init __gic_init(unsigned long gic_base_addr,
 			      unsigned int cpu_vec, unsigned int irqbase,
 			      struct device_node *node)
 {
-	unsigned int gicconfig;
+	unsigned int gicconfig, cpu;
 	unsigned int v[2];
 
 	__gic_base_addr = gic_base_addr;
@@ -973,6 +973,14 @@ static void __init __gic_init(unsigned long gic_base_addr,
 	gic_vpes = gic_vpes + 1;
 
 	if (cpu_has_veic) {
+		/* Set EIC mode for all VPEs */
+		for_each_present_cpu(cpu) {
+			gic_write(GIC_REG(VPE_LOCAL, GIC_VPE_OTHER_ADDR),
+				  mips_cm_vp_id(cpu));
+			gic_write(GIC_REG(VPE_OTHER, GIC_VPE_CTL),
+				  GIC_VPE_CTL_EIC_MODE_MSK);
+		}
+
 		/* Always use vector 1 in EIC mode */
 		gic_cpu_pin = 0;
 		timer_cpu_pin = gic_cpu_pin;
-- 
2.8.2