RE: [PATCH] Input: elan_i2c - +200 ms delay before setting to ABS mode

[廖崇榮]

Hi Dmitry,

The modification from Chris is a special case.
Because the Touchpad FW is a little different from normal one, It cause
problem in Asus's OBE test. 

That's why Elan's driver use work-around to solve the problem. It's not
tested by other touchpad.

Let me discuss with internal FW team to confirm the harmless of the patch.

B.R  KT
-----Original Message-----
From: Dmitry Torokhov [mailto:dmitry.torokhov@xxxxxxxxx] 
Sent: Tuesday, June 21, 2016 1:43 AM
To: Chris Chiu; kt.liao@xxxxxxxxxx
Cc: Charlie Mooney; Michele Curti; Krzysztof Kozlowski; Benson Leung;
linux-input@xxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx;
linux@xxxxxxxxxxxx
Subject: Re: [PATCH] Input: elan_i2c - +200 ms delay before setting to ABS
mode

On Tue, Jun 07, 2016 at 09:34:09PM +0800, Chris Chiu wrote:
> When performing a warm reboot from a system which does not correctly 
> support ELAN I2C touchpads, the touchpad will sometimes enter standard 
> mouse mode, cursor then never respond to touchpad event, and making 
> the driver discard the HID reports and flood dmesg with following 
> error messages.
> "elan_i2c i2c-ELAN1000:00: invalid report id data (1)"
> 
> This change is from ELAN's correction. It needs 200ms delay before
> set_mode() so that the mode setting will correctly take effect.

KT, is this feasible?

> 
> Signed-off-by: Chris Chiu <chiu@xxxxxxxxxxxx>
> ---
>  drivers/input/mouse/elan_i2c_core.c | 12 +++++++-----
>  1 file changed, 7 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/input/mouse/elan_i2c_core.c 
> b/drivers/input/mouse/elan_i2c_core.c
> index 2f58985..95080f9 100644
> --- a/drivers/input/mouse/elan_i2c_core.c
> +++ b/drivers/input/mouse/elan_i2c_core.c
> @@ -210,18 +210,20 @@ static int __elan_initialize(struct elan_tp_data
*data)
>  		return error;
>  	}
>  
> -	data->mode |= ETP_ENABLE_ABS;
> -	error = data->ops->set_mode(client, data->mode);
> +	error = data->ops->sleep_control(client, false);
>  	if (error) {
>  		dev_err(&client->dev,
> -			"failed to switch to absolute mode: %d\n", error);
> +			"failed to wake device up: %d\n", error);
>  		return error;
>  	}
>  
> -	error = data->ops->sleep_control(client, false);
> +	msleep(200);
> +
> +	data->mode |= ETP_ENABLE_ABS;
> +	error = data->ops->set_mode(client, data->mode);
>  	if (error) {
>  		dev_err(&client->dev,
> -			"failed to wake device up: %d\n", error);
> +			"failed to switch to absolute mode: %d\n", error);
>  		return error;
>  	}
>  
> --
> 2.1.4
> 

Thanks.

-- 
Dmitry