[PATCH 00/13] Revamp Semtech SX150x driver

[Andrey Smirnov]

Hello,

I am working with a hardware design utilizing SX1506 GPIO expander
(actually it uses 1503, but they seem to be the same from SW's point
of view) and following are the pathches I had to make in order to be
able to succesfully use part's driver from upstream kernel.

I am pretty certain I did not do any of the DT bindings in a proper
way, so I am more than happy to change all of that, or, due to the
fact I don't use any of those bindings in my usecase, drop them
alltogether.

Thank you,
Andrey Smirnov

Andrey Smirnov (13):
  gpio-sx150x: Remove 'gpio_base' from pdata
  gpio-sx150x: Remove 'irq_summary' parameter
  gpio-sx150x: Remove 'irq_base' parameter
  gpio-sx150x: Replace 'io_polarity' with DT binding
  bindings: gpio-sx150x: Document "semtech,io-polarity" binding
  gpio-sx150x: Replace "io_pull*_ena" with DT bindings
  bindings: gpio-sx150x: Document "semtech,io-pull*" bindings
  gpio-sx150x: Replace 'reset_during_probe" with DT binding
  bindings: gpio-sx150x: Document "semtech,reset-during-probe" bindings
  gpio-sx150x: Replace 'oscio_is_gpio' with DT binding
  bindings: gpio-sx150x: Document "semtech,oscio-is-gpo" binding
  gpio-sx150x: Remove struct sx150x_platform_data
  gpio-sx150x: Pass device type in DT match table

 .../devicetree/bindings/gpio/gpio-sx150x.txt       |  29 ++++
 drivers/gpio/gpio-sx150x.c                         | 184 +++++++++------------
 2 files changed, 105 insertions(+), 108 deletions(-)

-- 
2.5.5