[RFC PATCH] mtd: nand: Add OX820 NAND Support

[Neil Armstrong]

Add NAND driver to support the Oxford Semiconductor OX820 NAND Controller.
This is a simple memory mapped NAND controller with single chip select and
software ECC.

Signed-off-by: Neil Armstrong <narmstrong@xxxxxxxxxxxx>
---
 .../devicetree/bindings/mtd/oxnas-nand.txt         |  24 ++++
 drivers/mtd/nand/Kconfig                           |   5 +
 drivers/mtd/nand/Makefile                          |   1 +
 drivers/mtd/nand/oxnas_nand.c                      | 144 +++++++++++++++++++++
 4 files changed, 174 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/mtd/oxnas-nand.txt
 create mode 100644 drivers/mtd/nand/oxnas_nand.c

diff --git a/Documentation/devicetree/bindings/mtd/oxnas-nand.txt b/Documentation/devicetree/bindings/mtd/oxnas-nand.txt
new file mode 100644
index 0000000..83b684d
--- /dev/null
+++ b/Documentation/devicetree/bindings/mtd/oxnas-nand.txt
@@ -0,0 +1,24 @@
+* Oxford Semiconductor OXNAS NAND Controller
+
+Please refer to nand.txt for generic information regarding MTD NAND bindings.
+
+Required properties:
+ - compatible: "oxsemi,ox820-nand"
+ - reg: Base address and length for NAND mapped memory.
+
+Optional Properties:
+ - clocks: phandle to the NAND gate clock if needed.
+ - resets: phandle to the NAND reset control if needed.
+
+Example:
+
+nand: nand@41000000 {
+	compatible = "oxsemi,ox820-nand";
+	reg = <0x41000000 0x100000>;
+	nand-ecc-mode = "soft";
+	clocks = <&stdclk CLK_820_NAND>;
+	resets = <&reset RESET_NAND>;
+	#address-cells = <1>;
+	#size-cells = <1>;
+	status = "disabled";
+};
diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
index 7b7a887..c023125 100644
--- a/drivers/mtd/nand/Kconfig
+++ b/drivers/mtd/nand/Kconfig
@@ -426,6 +426,11 @@ config MTD_NAND_ORION
 	  No board specific support is done by this driver, each board
 	  must advertise a platform_device for the driver to attach.
 
+config MTD_NAND_OXNAS
+	tristate "NAND Flash support for Oxford Semiconductor SoC"
+	help
+	  This enables the NAND flash controller on Oxford Semiconductor SoCs.
+
 config MTD_NAND_FSL_ELBC
 	tristate "NAND support for Freescale eLBC controllers"
 	depends on FSL_SOC
diff --git a/drivers/mtd/nand/Makefile b/drivers/mtd/nand/Makefile
index cafde6f..05fc054 100644
--- a/drivers/mtd/nand/Makefile
+++ b/drivers/mtd/nand/Makefile
@@ -35,6 +35,7 @@ obj-$(CONFIG_MTD_NAND_TMIO)		+= tmio_nand.o
 obj-$(CONFIG_MTD_NAND_PLATFORM)		+= plat_nand.o
 obj-$(CONFIG_MTD_NAND_PASEMI)		+= pasemi_nand.o
 obj-$(CONFIG_MTD_NAND_ORION)		+= orion_nand.o
+obj-$(CONFIG_MTD_NAND_OXNAS)		+= oxnas_nand.o
 obj-$(CONFIG_MTD_NAND_FSL_ELBC)		+= fsl_elbc_nand.o
 obj-$(CONFIG_MTD_NAND_FSL_IFC)		+= fsl_ifc_nand.o
 obj-$(CONFIG_MTD_NAND_FSL_UPM)		+= fsl_upm.o
diff --git a/drivers/mtd/nand/oxnas_nand.c b/drivers/mtd/nand/oxnas_nand.c
new file mode 100644
index 0000000..ee402ab
--- /dev/null
+++ b/drivers/mtd/nand/oxnas_nand.c
@@ -0,0 +1,144 @@
+/*
+ * Oxford Semiconductor OXNAS NAND driver
+ *
+ * Heavily based on plat_nand.c :
+ * Author: Vitaly Wool <vitalywool@xxxxxxxxx>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ *
+ */
+
+#include <linux/err.h>
+#include <linux/io.h>
+#include <linux/module.h>
+#include <linux/platform_device.h>
+#include <linux/slab.h>
+#include <linux/clk.h>
+#include <linux/reset.h>
+#include <linux/mtd/mtd.h>
+#include <linux/mtd/nand.h>
+#include <linux/mtd/partitions.h>
+
+/* nand commands */
+#define NAND_CMD_ALE		BIT(18)
+#define NAND_CMD_CLE		BIT(19)
+#define NAND_CMD_CS		0
+#define NAND_CMD_RESET		0xff
+#define NAND_CMD		(NAND_CMD_CS | NAND_CMD_CLE)
+#define NAND_ADDR		(NAND_CMD_CS | NAND_CMD_ALE)
+#define NAND_DATA		(NAND_CMD_CS)
+
+struct oxnas_nand_data {
+	struct nand_chip	chip;
+	void __iomem		*io_base;
+	struct clk		*clk;
+};
+
+static void oxnas_nand_cmd_ctrl(struct mtd_info *mtd, int cmd,
+				unsigned int ctrl)
+{
+	struct nand_chip *this = mtd->priv;
+	unsigned long nandaddr = (unsigned long) this->IO_ADDR_W;
+
+	if (ctrl & NAND_CTRL_CHANGE) {
+		nandaddr &= ~(NAND_CMD | NAND_ADDR);
+		if (ctrl & NAND_CLE)
+			nandaddr |= NAND_CMD;
+		else if (ctrl & NAND_ALE)
+			nandaddr |= NAND_ADDR;
+		this->IO_ADDR_W = (void __iomem *) nandaddr;
+	}
+
+	if (cmd != NAND_CMD_NONE)
+		writeb(cmd, (void __iomem *) nandaddr);
+}
+
+/*
+ * Probe for the NAND device.
+ */
+static int oxnas_nand_probe(struct platform_device *pdev)
+{
+	struct oxnas_nand_data *data;
+	struct mtd_info *mtd;
+	struct resource *res;
+	int err = 0;
+
+	/* Allocate memory for the device structure (and zero it) */
+	data = devm_kzalloc(&pdev->dev, sizeof(struct oxnas_nand_data),
+			    GFP_KERNEL);
+	if (!data)
+		return -ENOMEM;
+
+	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+	data->io_base = devm_ioremap_resource(&pdev->dev, res);
+	if (IS_ERR(data->io_base))
+		return PTR_ERR(data->io_base);
+
+	data->clk = devm_clk_get(&pdev->dev, NULL);
+	if (IS_ERR(data->clk))
+		data->clk = NULL;
+
+	nand_set_flash_node(&data->chip, pdev->dev.of_node);
+	mtd = nand_to_mtd(&data->chip);
+	mtd->dev.parent = &pdev->dev;
+	mtd->priv = &data->chip;
+
+	data->chip.IO_ADDR_R = data->io_base;
+	data->chip.IO_ADDR_W = data->io_base;
+	data->chip.cmd_ctrl = oxnas_nand_cmd_ctrl;
+	data->chip.chip_delay = 30;
+	data->chip.ecc.mode = NAND_ECC_SOFT;
+	data->chip.ecc.algo = NAND_ECC_HAMMING;
+
+	platform_set_drvdata(pdev, data);
+
+	clk_prepare_enable(data->clk);
+	device_reset_optional(&pdev->dev);
+
+	/* Scan to find existence of the device */
+	if (nand_scan(mtd, 1)) {
+		err = -ENXIO;
+		goto out;
+	}
+
+	err = mtd_device_parse_register(mtd, NULL, NULL, NULL, 0);
+	if (!err)
+		return err;
+
+	nand_release(mtd);
+out:
+	return err;
+}
+
+static int oxnas_nand_remove(struct platform_device *pdev)
+{
+	struct oxnas_nand_data *data = platform_get_drvdata(pdev);
+
+	nand_release(nand_to_mtd(&data->chip));
+
+	return 0;
+}
+
+static const struct of_device_id oxnas_nand_match[] = {
+	{ .compatible = "oxsemi,ox820-nand" },
+	{},
+};
+MODULE_DEVICE_TABLE(of, oxnas_nand_match);
+
+static struct platform_driver oxnas_nand_driver = {
+	.probe	= oxnas_nand_probe,
+	.remove	= oxnas_nand_remove,
+	.driver	= {
+		.name		= "oxnas_nand",
+		.of_match_table = oxnas_nand_match,
+	},
+};
+
+module_platform_driver(oxnas_nand_driver);
+
+MODULE_LICENSE("GPL");
+MODULE_AUTHOR("Vitaly Wool");
+MODULE_DESCRIPTION("Oxnas NAND driver");
+MODULE_ALIAS("platform:oxnas_nand");
-- 
2.7.0