[PATCH 2/2] sdhci: Prevent SD from doing high-speed timing when broken-highspeed property is set

[Zach Brown]

When the broken-highspeed property is set the sdhci driver will not
go into highspeed mode even if the controller and card appear to
otherwise support highspeed mode.

This is useful in cases where the controller and card support highspeed,
but the board configuration or some other issue make highspeed
impossible. For example, we send the SDIO lines through a fpga so we
need the data to change on the falling edge of the clock or there will
be issues with hold time.

Signed-off-by: Zach Brown <zach.brown@xxxxxx>
Acked-by: Adrian Hunter <adrian.hunter@xxxxxxxxx>
---
 drivers/mmc/host/sdhci.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 1e25b01..4ec44fd 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -22,6 +22,7 @@
 #include <linux/scatterlist.h>
 #include <linux/regulator/consumer.h>
 #include <linux/pm_runtime.h>
+#include <linux/of.h>
 
 #include <linux/leds.h>
 
@@ -3269,7 +3270,8 @@ int sdhci_setup_host(struct sdhci_host *host)
 	if (host->quirks2 & SDHCI_QUIRK2_HOST_NO_CMD23)
 		mmc->caps &= ~MMC_CAP_CMD23;
 
-	if (host->caps & SDHCI_CAN_DO_HISPD)
+	if ((host->caps & SDHCI_CAN_DO_HISPD) &&
+	    !(of_property_read_bool(mmc_dev(mmc)->of_node, "broken-highspeed")))
 		mmc->caps |= MMC_CAP_SD_HIGHSPEED | MMC_CAP_MMC_HIGHSPEED;
 
 	if ((host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION) &&
-- 
2.7.4