[PATCH] ARM: dts: sun8i: Add SPI controller node in H3

[Milo Kim]

H3 supports two SPI controllers. Four pins (MOSI, MISO, SCLK, SS) are
configured through the pinctrl subsystem. It is almost same as A31 SPI
except buffer size, so those DT properties are reusable.

Cc: Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx>
Cc: Chen-Yu Tsai <wens@xxxxxxxx>
Signed-off-by: Milo Kim <woogyom.kim@xxxxxxxxx>
---
 arch/arm/boot/dts/sun8i-h3.dtsi | 46 +++++++++++++++++++++++++++++++++++++++++
 1 file changed, 46 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-h3.dtsi b/arch/arm/boot/dts/sun8i-h3.dtsi
index 75a8654..c38b028 100644
--- a/arch/arm/boot/dts/sun8i-h3.dtsi
+++ b/arch/arm/boot/dts/sun8i-h3.dtsi
@@ -381,6 +381,20 @@
 				allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;
 			};
 
+			spi0_pins: spi0 {
+				allwinner,pins = "PC0", "PC1", "PC2", "PC3";
+				allwinner,function = "spi0";
+				allwinner,drive = <SUN4I_PINCTRL_10_MA>;
+				allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;
+			};
+
+			spi1_pins: spi1 {
+				allwinner,pins = "PA15", "PA16", "PA14", "PA13";
+				allwinner,function = "spi1";
+				allwinner,drive = <SUN4I_PINCTRL_10_MA>;
+				allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;
+			};
+
 			uart0_pins_a: uart0@0 {
 				allwinner,pins = "PA4", "PA5";
 				allwinner,function = "uart0";
@@ -425,6 +439,38 @@
 			clocks = <&osc24M>;
 		};
 
+		spi0: spi@01c68000 {
+			compatible = "allwinner,sun8i-h3-spi";
+			reg = <0x01c68000 0x1000>;
+			interrupts = <GIC_SPI 65 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&ccu CLK_BUS_SPI0>, <&ccu CLK_SPI0>;
+			clock-names = "ahb", "mod";
+			dmas = <&dma 23>, <&dma 23>;
+			dma-names = "rx", "tx";
+			pinctrl-names = "default";
+			pinctrl-0 = <&spi0_pins>;
+			resets = <&ccu RST_BUS_SPI0>;
+			status = "disabled";
+			#address-cells = <1>;
+			#size-cells = <0>;
+		};
+
+		spi1: spi@01c69000 {
+			compatible = "allwinner,sun8i-h3-spi";
+			reg = <0x01c69000 0x1000>;
+			interrupts = <GIC_SPI 66 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&ccu CLK_BUS_SPI1>, <&ccu CLK_SPI1>;
+			clock-names = "ahb", "mod";
+			dmas = <&dma 24>, <&dma 24>;
+			dma-names = "rx", "tx";
+			pinctrl-names = "default";
+			pinctrl-0 = <&spi1_pins>;
+			resets = <&ccu RST_BUS_SPI1>;
+			status = "disabled";
+			#address-cells = <1>;
+			#size-cells = <0>;
+		};
+
 		wdt0: watchdog@01c20ca0 {
 			compatible = "allwinner,sun6i-a31-wdt";
 			reg = <0x01c20ca0 0x20>;
-- 
2.9.3