Re: [PATCH V4 2/3] Revert "ACPI,PCI,IRQ: remove SCI penalize function"

From: Bjorn Helgaas
Date: Sat Oct 22 2016 - 19:29:08 EST


On Thu, Oct 20, 2016 at 08:58:14PM -0500, Bjorn Helgaas wrote:
> On Wed, Oct 19, 2016 at 06:21:03PM -0400, Sinan Kaya wrote:
> > The SCI penalize function was removed in two steps (first refactor
> > and then remove) and these changes are reverted here in one go.
> >
> > The commit 103544d86976 ("ACPI,PCI,IRQ: reduce resource requirements")
> > refactored the original code so that SCI penalty is calculated dynamically
> > by the time get_penalty function is called. That change is partially
> > reverted here, specifically for the SCI IRQ alone.
> >
> > The SCI penalize function was finally dropped by commit 9e5ed6d1fb87
> > ("ACPI,PCI,IRQ: remove SCI penalize function") that replaced the old SCI
> > penalty API with penalty calculation carried out dynamically and based
> > on the acpi_gbl_FADT.sci_interrupt value.
> >
> > However, that new algorithm relies on the accurate setting of IRQ
> > types and that doesn't happen early enough on some platforms which
> > leads to incorrect penalty assignments for PCI IRQs. In those cases,
> > irq_get_trigger_type() returns incorrect values for the IRQs in
> > question, because they have not been registered yet by the time the
> > penalties are calculated.
> >
> > To fix this problem, we only need to fix the penalty for the SCI interrupt.
> > It seems better to add a single "sci_penalty" variable, set it to
> > PIRQ_PENALTY_PCI_USING if it's level/low or PIRQ_PENALTY_ISA_ALWAYS
> > otherwise, and add "sci_penalty" in when appropriate. That should fix it
> > for *any* SCI IRQ, not just those less than 256, and we don't have to add
> > these extra penalty table entries that are all unused (except possibly for
> > one entry if we have an SCI in the 16-255 range).
> >
> > For this reason, revert commit 9e5ed6d1fb87 ("ACPI,PCI,IRQ: remove SCI
> > penalize function") completely to restore the correct behavior.
>
> I like this patch fine, except for the changelog. I don't think it's
> useful to describe this as a revert and give all the historical
> details. I think the important part is something like this:
>
> We previously used irq_get_trigger_type(irq) to help compute the
> penalty for the SCI, but that depends on the SCI having been
> registered already. Add acpi_penalize_sci_irq() so platforms can
> tell us the SCI IRQ, trigger, and polarity so we can compute the
> penalty even before the SCI has been registered.

I think this is actually the critical patch that fixes the regression
reported by Ondrej, so the changelog really should include details
about the regression, e.g., something like this:

ACPI: pci_link: Penalize SCI correctly

Ondrej reported that IRQs stopped working in v4.7 on several
platforms. A typical scenario, from Ondrej's VT82C694X/694X, is:

ACPI: Using PIC for interrupt routing
ACPI: PCI Interrupt Link [LNKA] (IRQs 1 3 4 5 6 7 10 *11 12 14 15)
ACPI: No IRQ available for PCI Interrupt Link [LNKA]
8139too 0000:00:0f.0: PCI INT A: no GSI

We're using PIC routing, so acpi_irq_balance == 0, and LNKA is already
active at IRQ 11. In that case, acpi_pci_link_allocate() only tries
to use the active IRQ (IRQ 11) which also happens to be the SCI.

We should penalize the SCI by PIRQ_PENALTY_PCI_USING, but
irq_get_trigger_type(11) returns something other than
IRQ_TYPE_LEVEL_LOW, so we penalize it by PIRQ_PENALTY_ISA_ALWAYS
instead, which makes acpi_pci_link_allocate() assume the IRQ isn't
available and give up.

Add acpi_penalize_sci_irq() so platforms can tell us the SCI IRQ,
trigger, and polarity directly and we don't have to depend on
irq_get_trigger_type().

Link: http://lkml.kernel.org/r/201609251512.05657.linux@xxxxxxxxxxxxxxxxxxxx
Reported-by: Ondrej Zary <linux@xxxxxxxxxxxxxxxxxxxx>

I don't understand what's broken about using irq_get_trigger_type().
The SCI is registered in the following path, which is certainly before
we try to enable LNKA for the 8139too device:

acpi_init # subsys_initcall
acpi_bus_init
acpi_enable_subsystem
acpi_ev_install_xrupt_handlers
acpi_ev_install_sci_handler
acpi_os_install_interrupt_handler(sci_interrupt, ...)
acpi_gsi_to_irq
acpi_register_gsi
irq_create_fwspec_mapping
irqd_set_trigger_type

In any event, I think this patch to add acpi_penalize_sci_irq() is
fine.

> Acked-by: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>
>
> > Link: https://lkml.org/lkml/2016/10/4/283
> > Signed-off-by: Sinan Kaya <okaya@xxxxxxxxxxxxxx>
> > Fixes: commit 103544d86976 ("ACPI,PCI,IRQ: reduce resource requirements")
> > Fixes: commit 9e5ed6d1fb87 ("ACPI,PCI,IRQ: remove SCI penalize function")
>
> "commit" is redundant; it's sufficient to say:
>
> Fixes: 103544d86976 ("ACPI,PCI,IRQ: reduce resource requirements")
>
> In fact, I don't think you really need to include "commit" in the
> reference to 9e5ed6d1fb87 above either.
>
> > ---
> > arch/x86/kernel/acpi/boot.c | 1 +
> > drivers/acpi/pci_link.c | 30 +++++++++++++++---------------
> > include/linux/acpi.h | 1 +
> > 3 files changed, 17 insertions(+), 15 deletions(-)
> >
> > diff --git a/arch/x86/kernel/acpi/boot.c b/arch/x86/kernel/acpi/boot.c
> > index 90d84c3..0ffd26e 100644
> > --- a/arch/x86/kernel/acpi/boot.c
> > +++ b/arch/x86/kernel/acpi/boot.c
> > @@ -453,6 +453,7 @@ static void __init acpi_sci_ioapic_setup(u8 bus_irq, u16 polarity, u16 trigger,
> > polarity = acpi_sci_flags & ACPI_MADT_POLARITY_MASK;
> >
> > mp_override_legacy_irq(bus_irq, polarity, trigger, gsi);
> > + acpi_penalize_sci_irq(bus_irq, trigger, polarity);
> >
> > /*
> > * stash over-ride to indicate we've been here
> > diff --git a/drivers/acpi/pci_link.c b/drivers/acpi/pci_link.c
> > index 4f37938..294b190 100644
> > --- a/drivers/acpi/pci_link.c
> > +++ b/drivers/acpi/pci_link.c
> > @@ -87,6 +87,7 @@ struct acpi_pci_link {
> >
> > static LIST_HEAD(acpi_link_list);
> > static DEFINE_MUTEX(acpi_link_lock);
> > +static int sci_irq = -1, sci_penalty;
> >
> > /* --------------------------------------------------------------------------
> > PCI Link Device Management
> > @@ -496,25 +497,13 @@ static int acpi_irq_get_penalty(int irq)
> > {
> > int penalty = 0;
> >
> > - /*
> > - * Penalize IRQ used by ACPI SCI. If ACPI SCI pin attributes conflict
> > - * with PCI IRQ attributes, mark ACPI SCI as ISA_ALWAYS so it won't be
> > - * use for PCI IRQs.
> > - */
> > - if (irq == acpi_gbl_FADT.sci_interrupt) {
> > - u32 type = irq_get_trigger_type(irq) & IRQ_TYPE_SENSE_MASK;
> > -
> > - if (type != IRQ_TYPE_LEVEL_LOW)
> > - penalty += PIRQ_PENALTY_ISA_ALWAYS;
> > - else
> > - penalty += PIRQ_PENALTY_PCI_USING;
> > - }
> > + if (irq == sci_irq)
> > + penalty += sci_penalty;
> >
> > if (irq < ACPI_MAX_ISA_IRQS)
> > return penalty + acpi_isa_irq_penalty[irq];
> >
> > - penalty += acpi_irq_pci_sharing_penalty(irq);
> > - return penalty;
> > + return penalty + acpi_irq_pci_sharing_penalty(irq);
> > }
> >
> > int __init acpi_irq_penalty_init(void)
> > @@ -881,6 +870,17 @@ bool acpi_isa_irq_available(int irq)
> > acpi_irq_get_penalty(irq) < PIRQ_PENALTY_ISA_ALWAYS);
> > }
> >
> > +void acpi_penalize_sci_irq(int irq, int trigger, int polarity)
> > +{
> > + sci_irq = irq;
> > +
> > + if (trigger == ACPI_MADT_TRIGGER_LEVEL &&
> > + polarity == ACPI_MADT_POLARITY_ACTIVE_LOW)
> > + sci_penalty = PIRQ_PENALTY_PCI_USING;
> > + else
> > + sci_penalty = PIRQ_PENALTY_ISA_ALWAYS;
> > +}
> > +
> > /*
> > * Over-ride default table to reserve additional IRQs for use by ISA
> > * e.g. acpi_irq_isa=5
> > diff --git a/include/linux/acpi.h b/include/linux/acpi.h
> > index c5eaf2f..67d1d3e 100644
> > --- a/include/linux/acpi.h
> > +++ b/include/linux/acpi.h
> > @@ -318,6 +318,7 @@ struct pci_dev;
> > int acpi_pci_irq_enable (struct pci_dev *dev);
> > void acpi_penalize_isa_irq(int irq, int active);
> > bool acpi_isa_irq_available(int irq);
> > +void acpi_penalize_sci_irq(int irq, int trigger, int polarity);
> > void acpi_pci_irq_disable (struct pci_dev *dev);
> >
> > extern int ec_read(u8 addr, u8 *val);
> > --
> > 1.9.1
> >
> >
> > _______________________________________________
> > linux-arm-kernel mailing list
> > linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
> --
> To unsubscribe from this list: send the line "unsubscribe linux-acpi" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at http://vger.kernel.org/majordomo-info.html