Re: [PATCH v6 5/5] ARM: DTS: da850: Add usb phy node

[David Lechner]

On 10/26/2016 05:26 AM, Sekhar Nori wrote:
> On Wednesday 26 October 2016 08:36 AM, David Lechner wrote:
> > Add a node for the new usb phy driver.
>
> changed this to:
>
>     Add a node for usb phy device. This device
>     controls both the USB 1.1 and USB 2.0 PHYs.
>
> mainly because the node is for the device, not the driver.
>
> > Signed-off-by: David Lechner <david@xxxxxxxxxxxxxx>
>
> Applied to v4.10/dt
>
> Thanks,
> Sekhar

I found a better way to represent this device as a child of the syscon 
node. How should we handle the change? Should I submit a new patch that 
applies on top of this one or will you drop this patch and I should send 
a new one to take it's place?

Assuming that you agree that this is better:

	cfgchip: cfgchip@1417c {
		compatible = "ti,da830-cfgchip", "syscon", "simple-mfd";
		reg = <0x1417c 0x14>;

		usb_phy: usb-phy {
			compatible = "ti,da830-usb-phy";
			#phy-cells = <1>;
			status = "disabled";
		};
	};

Since the phy consists entirely as registers in the syscon device, we 
should make it a child of the syscon device instead of a child of the 
soc node.