Re: [BUG nohz]: wrong user and system time accounting

[Rik van Riel]

On Tue, 2017-04-04 at 13:36 -0400, Luiz Capitulino wrote:
>Â
> On further debugging this, I realized that I had overlooked
> something:
> the timer interrupt in this trace is not the tick, but cyclictest's
> timer
> (remember that the test-case consists of pinning cyclictest and a
> task
> hogging the CPU to the same CPU).
> 
> I'm running cyclictest with -i 200. If I increase this to -i 1000,
> then
> I seem unable to reproduce the issue (caution: even with -i 200 it
> doesn't always happen. But it does usually happen after I restart the
> test-case a few times. However, I've never been able to reproduce
> with -i 1000).
> 
> Now, if it's really cyclictest that's causing the timer interrupts to
> get aligned, I guess this might not have a solution? (note: I haven't
> been able to reproduce this on bare-metal).

With any sample (tick) based timekeeping, it is possible
to construct workloads that avoid the sampling and result
in skewed statistics as a result.

However, given that local users can already DoS the system
in all kinds of ways, skewed statistics are probably not
that high up on the list of importance.

If there were a way to do accurate accounting (true vtime
accounting) without increasing the overhead of every
syscall and interrupt noticeably, that might be worth it,
but syscall overhead is likely to be a more important
factor than the accuracy of statistics.

I don't know if doing TSC reads and subtraction/addition
only, and delaying the conversion to cputime until a later
point would slow down system calls measurably, compared
with reading jiffies and comparing it against a cached
value of jiffies, nor do I know whether spending time
implementing and testing that would be worthwhile :)

-- 
All rights reversed

Attachment: signature.asc
Description: This is a digitally signed message part