Re: [PATCH v3 3/4] dt-bindings: power: tps65217_charger: add NTC type for battery temperature measurement.

From: Liam Breck
Date: Fri May 26 2017 - 21:17:24 EST


Hi Enric,

On Fri, May 26, 2017 at 4:04 AM, Enric Balletbo i Serra
<enric.balletbo@xxxxxxxxxxxxx> wrote:
> The TS pin of the TPS56217 connects to the NTC resistor in the battery
> pack. By default the device is setup to support a 10-kohm but can also
> be configured to support a 100-kohm. Add a propietry to configure the
> connected NTC resistor. Therefore, the charger would get the wrong
> temperature information.

This also needs a monitored-battery property, and a battery node in
the example. See https://patchwork.kernel.org/patch/9710803/


> Signed-off-by: Enric Balletbo i Serra <enric.balletbo@xxxxxxxxxxxxx>
> ---
> Changes since v2:
> - Requested by Sebastian Reichel
> - Get rid of common properties and only maintain ntc-type.
> Changes since v1:
> - None
>
> .../devicetree/bindings/power/supply/tps65217_charger.txt | 7 +++++++
> 1 file changed, 7 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/power/supply/tps65217_charger.txt b/Documentation/devicetree/bindings/power/supply/tps65217_charger.txt
> index a11072c..851f5c7 100644
> --- a/Documentation/devicetree/bindings/power/supply/tps65217_charger.txt
> +++ b/Documentation/devicetree/bindings/power/supply/tps65217_charger.txt
> @@ -6,6 +6,12 @@ Required Properties:
> Should be <0> for the USB charger and <1> for the AC adapter.
> -interrupt-names: Should be "USB" and "AC"
>
> +Optional properties:
> +-ti,ntc-type: set the NTC type for battery temperature measurement. The value
> + must be 0 or 1, where:
> + 0 â 100k (curve 1, B = 3960)
> + 1 â 10k (curve 2, B = 3480) (default)
> +
> This node is a subnode of the tps65217 PMIC.
>
> Example:
> @@ -14,4 +20,5 @@ Example:
> compatible = "ti,tps65217-charger";
> interrupts = <0>, <1>;
> interrupt-names = "USB", "AC";
> + ti,ntc-type = <1>;
> };
> --
> 2.9.3
>