Re: [PATCH] mailbox: add support for doorbell/signal mode controllers

[Sudeep Holla]

On 01/11/17 18:03, Jassi Brar wrote:
> On Wed, Nov 1, 2017 at 10:02 PM, Sudeep Holla <sudeep.holla@xxxxxxx> wrote:
> 
>>
>> Such controllers don't need to transmit any data, they just transmit
>> the signal. In such controllers the data pointer passed to
>> mbox_send_message is passed to client via it's tx_prepare callback.
>> Controller doesn't need any data to be passed from the client.
>>
> Some controllers need a non-zero value written to a register in order
> to trigger the signal.

You are right, just right non-zero or whatever controller value to
trigger the interrupt to remote.

> That register is visible to the remote. While the data/packet is setup
> during tx_prepare() callback.

Agreed.

> You are overlooking this class of doorbell controllers.
>

Not sure what do you mean by that ?

>>
>> This is rough idea I have on extending mailbox interface to support
>> the doorbell requirements.
>>
> What doorbell requirements does the api not support?
> QComm's APCS IPC is what you call a "doorbell" controller and is
> already supported by the API. It could run SCMI even easier than MHU
> (your controller).
> 

Again agreed. But see below for reason to create this API.

>> The new API send_signal will eliminate the
>> issue Jassi has explained in earlier discussion with respect to generic
>> message format using Rockchip example.
>>
> Sorry I don't see how.
> Please explain how can send_signal() api be used by, say, rockchip to
> support SCMI?
> 

 80         writel_relaxed(msg->cmd, mb->mbox_base +
MAILBOX_A2B_CMD(chans->idx));
 81         writel_relaxed(msg->rx_size, mb->mbox_base +

 82                        MAILBOX_A2B_DAT(chans->idx));

 83

 will be replaced with

writel(whatever_value_to trigger_signal, MAILBOX_A2B_CMD(chans->idx));

in its send_signal function.

> I am not convinced we should clone an api just so that a client driver
> becomes simpler. Esp when it shifts, and not avoid, the additional
> code (to support the client) onto the provider side.
> 

It doesn't tie the data format with particular mailbox controller.
send_data has void *data and the interpretation is controller specific.
send_signal on the other handle can implemented by the controllers which
knows how and can trigger the specific signal to the remote.
-- 
Regards,
Sudeep