Re: [PATCH V4 03/12] drivers: Add boot constraints core

[Greg Kroah-Hartman]

On Sun, Oct 29, 2017 at 07:18:51PM +0530, Viresh Kumar wrote:
> Some devices are powered ON by the bootloader before the bootloader
> handovers control to Linux. It maybe important for those devices to keep
> working until the time a Linux device driver probes the device and
> reconfigure its resources.
> 
> A typical example of that can be the LCD controller, which is used by
> the bootloaders to show image(s) while the platform is booting into
> Linux. The LCD controller can be using some resources, like clk,
> regulators, PM domain, etc, that are shared between several devices.
> These shared resources should be configured to satisfy need of all the
> users. If another device's (X) driver gets probed before the LCD
> controller driver in this case, then it may end up reconfiguring these
> resources to ranges satisfying the current users (only device X) and
> that can make the LCD screen unstable.
> 
> This patch introduces the concept of boot-constraints, which will be set
> by the bootloaders and the kernel will satisfy them until the time
> driver for such a device is probed (successfully or unsuccessfully).
> 
> The list of boot constraint types is empty for now, and will be
> incrementally updated by later patches.
> 
> Only two routines are exposed by the boot constraints core for now:
> 
> - dev_boot_constraint_add(): This shall be called by parts of the kernel
>   (before the device is probed) to set the constraints.
> 
> - dev_boot_constraints_remove(): This is called only by the driver core
>   after a device is probed successfully or unsuccessfully. Special
>   handling is done here for deferred probing.
> 
> Tested-by: Rajendra Nayak <rnayak@xxxxxxxxxxxxxx>
> Signed-off-by: Viresh Kumar <viresh.kumar@xxxxxxxxxx>

Minor nits:

> ---
>  drivers/Kconfig                   |   2 +
>  drivers/Makefile                  |   1 +
>  drivers/base/dd.c                 |  20 ++--
>  drivers/boot_constraints/Kconfig  |   9 ++
>  drivers/boot_constraints/Makefile |   3 +
>  drivers/boot_constraints/core.c   | 199 ++++++++++++++++++++++++++++++++++++++
>  drivers/boot_constraints/core.h   |  33 +++++++
>  include/linux/boot_constraint.h   |  46 +++++++++
>  8 files changed, 306 insertions(+), 7 deletions(-)
>  create mode 100644 drivers/boot_constraints/Kconfig
>  create mode 100644 drivers/boot_constraints/Makefile
>  create mode 100644 drivers/boot_constraints/core.c
>  create mode 100644 drivers/boot_constraints/core.h
>  create mode 100644 include/linux/boot_constraint.h
> 
> diff --git a/drivers/Kconfig b/drivers/Kconfig
> index 505c676fa9c7..e595ffad2214 100644
> --- a/drivers/Kconfig
> +++ b/drivers/Kconfig
> @@ -4,6 +4,8 @@ source "drivers/amba/Kconfig"
>  
>  source "drivers/base/Kconfig"
>  
> +source "drivers/boot_constraints/Kconfig"
> +
>  source "drivers/bus/Kconfig"
>  
>  source "drivers/connector/Kconfig"
> diff --git a/drivers/Makefile b/drivers/Makefile
> index d90fdc413648..29d03466cb2a 100644
> --- a/drivers/Makefile
> +++ b/drivers/Makefile
> @@ -72,6 +72,7 @@ obj-$(CONFIG_FB_INTEL)          += video/fbdev/intelfb/
>  obj-$(CONFIG_PARPORT)		+= parport/
>  obj-$(CONFIG_NVM)		+= lightnvm/
>  obj-y				+= base/ block/ misc/ mfd/ nfc/
> +obj-$(CONFIG_DEV_BOOT_CONSTRAINTS) += boot_constraints/
>  obj-$(CONFIG_LIBNVDIMM)		+= nvdimm/
>  obj-$(CONFIG_DAX)		+= dax/
>  obj-$(CONFIG_DMA_SHARED_BUFFER) += dma-buf/
> diff --git a/drivers/base/dd.c b/drivers/base/dd.c
> index ad44b40fe284..4eec27fe2b2b 100644
> --- a/drivers/base/dd.c
> +++ b/drivers/base/dd.c
> @@ -17,6 +17,7 @@
>   * This file is released under the GPLv2
>   */

Can you rebase this patch, I think it will have conflicts or fuzz here.

>  
> +#include <linux/boot_constraint.h>
>  #include <linux/device.h>
>  #include <linux/delay.h>
>  #include <linux/dma-mapping.h>
> @@ -409,15 +410,20 @@ static int really_probe(struct device *dev, struct device_driver *drv)
>  	 */
>  	devices_kset_move_last(dev);
>  
> -	if (dev->bus->probe) {
> +	if (dev->bus->probe)
>  		ret = dev->bus->probe(dev);
> -		if (ret)
> -			goto probe_failed;
> -	} else if (drv->probe) {
> +	else if (drv->probe)
>  		ret = drv->probe(dev);
> -		if (ret)
> -			goto probe_failed;
> -	}
> +
> +	/*
> +	 * Remove boot constraints for both successful and unsuccessful probe(),
> +	 * except for the case where EPROBE_DEFER is returned by probe().
> +	 */
> +	if (ret != -EPROBE_DEFER)
> +		dev_boot_constraints_remove(dev);

This feels odd, but ok, I trust you :)

> +
> +	if (ret)
> +		goto probe_failed;
>  
>  	if (test_remove) {
>  		test_remove = false;
> diff --git a/drivers/boot_constraints/Kconfig b/drivers/boot_constraints/Kconfig
> new file mode 100644
> index 000000000000..77831af1c6fb
> --- /dev/null
> +++ b/drivers/boot_constraints/Kconfig
> @@ -0,0 +1,9 @@
> +config DEV_BOOT_CONSTRAINTS
> +	bool "Boot constraints for devices"
> +	help
> +	  This enables boot constraints detection for devices. These constraints
> +	  are (normally) set by the Bootloader and must be satisfied by the
> +	  kernel until the relevant device driver is probed. Once the driver is
> +	  probed, the constraint is dropped.
> +
> +	  If unsure, say N.
> diff --git a/drivers/boot_constraints/Makefile b/drivers/boot_constraints/Makefile
> new file mode 100644
> index 000000000000..0f2680177974
> --- /dev/null
> +++ b/drivers/boot_constraints/Makefile
> @@ -0,0 +1,3 @@
> +# Makefile for device boot constraints
> +
> +obj-y := core.o
> diff --git a/drivers/boot_constraints/core.c b/drivers/boot_constraints/core.c
> new file mode 100644
> index 000000000000..366a05d6d9ba
> --- /dev/null
> +++ b/drivers/boot_constraints/core.c
> @@ -0,0 +1,199 @@
> +/*
> + * This takes care of boot time device constraints, normally set by the
> + * Bootloader.
> + *
> + * Copyright (C) 2017 Linaro.
> + * Viresh Kumar <viresh.kumar@xxxxxxxxxx>
> + *
> + * This file is released under the GPLv2.

Care to update this patch with the new SPDX format for licenses?

> + */
> +
> +#define pr_fmt(fmt) "Boot Constraints: " fmt

You don't have any pr_* calls, so this isn't needed :)

> +struct constraint {
> +	struct constraint_dev *cdev;
> +	struct list_head node;
> +	enum dev_boot_constraint_type type;
> +	void (*free_resources)(void *data);
> +	void *free_resources_data;
> +
> +	int (*add)(struct constraint *constraint, void *data);
> +	void (*remove)(struct constraint *constraint);
> +	void *private;
> +};
> +
> +/* Forward declarations of constraint specific callbacks */
> +#endif /* _CORE_H */

What is this comment at the end of the file for?

> diff --git a/include/linux/boot_constraint.h b/include/linux/boot_constraint.h
> new file mode 100644
> index 000000000000..2b816bf74144
> --- /dev/null
> +++ b/include/linux/boot_constraint.h
> @@ -0,0 +1,46 @@
> +/*
> + * Boot constraints header.
> + *
> + * Copyright (C) 2017 Linaro.
> + * Viresh Kumar <viresh.kumar@xxxxxxxxxx>
> + *
> + * This file is released under the GPLv2
> + */
> +#ifndef _LINUX_BOOT_CONSTRAINT_H
> +#define _LINUX_BOOT_CONSTRAINT_H
> +
> +#include <linux/err.h>
> +#include <linux/types.h>
> +
> +struct device;
> +
> +enum dev_boot_constraint_type {
> +	DEV_BOOT_CONSTRAINT_NONE,
> +};
> +
> +struct dev_boot_constraint {
> +	enum dev_boot_constraint_type type;
> +	void *data;
> +};
> +
> +struct dev_boot_constraint_info {
> +	struct dev_boot_constraint constraint;
> +
> +	/* This will be called just before the constraint is removed */
> +	void (*free_resources)(void *data);
> +	void *free_resources_data;
> +};
> +
> +#ifdef CONFIG_DEV_BOOT_CONSTRAINTS
> +int dev_boot_constraint_add(struct device *dev,
> +			    struct dev_boot_constraint_info *info);
> +void dev_boot_constraints_remove(struct device *dev);
> +#else
> +static inline
> +int dev_boot_constraint_add(struct device *dev,
> +			    struct dev_boot_constraint_info *info)
> +{ return -EINVAL; }

Why return an error?  Shouldn't this just "succeed" if the option is not
built in?  What will you do with it if it fails because of this?

thanks,

greg k-h