[PATCH] regmap: use proper part of work_buf for storing val

[Krzysztof Adamski]

The map->work_buf is a buffer preallocated in __regmap_init() with size
allowing it to store all 3 parts of a buffer - reg, pad and val. While
reg and val parts are always properly setup before each transaction, the
pad part is left at its default value (zeros). Until it is overwritten,
that is.

_regmap_bus_read(), when calling _regmap_raw_read() uses beginning of
work_buf as a place to store data read. Usually that is fine but if
val_bits > reg_bits && pad_bits > 0, padding area of work_buf() may get
overwritten. Since padding is not zeroed before each transaction,
garbage will be used on next calls.

This patch moves the val pointer used for _regmap_raw_read() to point
to a part of work_buf intended for storing value read.

Signed-off-by: Krzysztof Adamski <krzysztof.adamski@xxxxxxxxx>
Signed-off-by: Mark Brown <broonie@xxxxxxxxxx>
---
 drivers/base/regmap/regmap.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/base/regmap/regmap.c b/drivers/base/regmap/regmap.c
index 8d516a9bfc01..9fb3a792642b 100644
--- a/drivers/base/regmap/regmap.c
+++ b/drivers/base/regmap/regmap.c
@@ -2423,13 +2423,15 @@ static int _regmap_bus_read(void *context, unsigned int reg,
 {
 	int ret;
 	struct regmap *map = context;
+	void *work_val = map->work_buf + map->format.reg_bytes +
+		map->format.pad_bytes;
 
 	if (!map->format.parse_val)
 		return -EINVAL;
 
-	ret = _regmap_raw_read(map, reg, map->work_buf, map->format.val_bytes);
+	ret = _regmap_raw_read(map, reg, work_val, map->format.val_bytes);
 	if (ret == 0)
-		*val = map->format.parse_val(map->work_buf);
+		*val = map->format.parse_val(work_val);
 
 	return ret;
 }
-- 
2.15.1