[PATCH] mmc: dw_mmc: update kernel-doc comments for dw_mci
From: Alexey Roslyakov
Date: Thu Feb 22 2018 - 14:46:34 EST
cur_slot and num_slots has been removed from struct dw_mci in 42f989c002f2.
Unfortunately, inline documentation was not updated so far.
Fix @lock field documentation in Locking section.
Move @mrq field of struct dw_mci_slot mention closer to it
description, so no one could miss this slightest detail.
Couple of code style fixes as a bonus.
Signed-off-by: Alexey Roslyakov <alexey.roslyakov@xxxxxxxxx>
---
drivers/mmc/host/dw_mmc.h | 19 +++++++++----------
1 file changed, 9 insertions(+), 10 deletions(-)
diff --git a/drivers/mmc/host/dw_mmc.h b/drivers/mmc/host/dw_mmc.h
index e3124f06a47e..451bc0862493 100644
--- a/drivers/mmc/host/dw_mmc.h
+++ b/drivers/mmc/host/dw_mmc.h
@@ -65,8 +65,7 @@ struct dw_mci_dma_slave {
* @fifo_reg: Pointer to MMIO registers for data FIFO
* @sg: Scatterlist entry currently being processed by PIO code, if any.
* @sg_miter: PIO mapping scatterlist iterator.
- * @cur_slot: The slot which is currently using the controller.
- * @mrq: The request currently being processed on @cur_slot,
+ * @mrq: The request currently being processed on @slot,
* or NULL if the controller is idle.
* @cmd: The command currently being sent to the card, or NULL.
* @data: The data currently being transferred, or NULL if no data
@@ -102,7 +101,6 @@ struct dw_mci_dma_slave {
* @bus_hz: The rate of @mck in Hz. This forms the basis for MMC bus
* rate and timeout calculations.
* @current_speed: Configured rate of the controller.
- * @num_slots: Number of slots available.
* @fifoth_val: The value of FIFOTH register.
* @verid: Denote Version ID.
* @dev: Device associated with the MMC controller.
@@ -134,17 +132,17 @@ struct dw_mci_dma_slave {
* =======
*
* @lock is a softirq-safe spinlock protecting @queue as well as
+ * @slot, @mrq and @state. These must always be updated
* at the same time while holding @lock.
+ * The @mrq field of struct dw_mci_slot is also protected by @lock,
+ * and must always be written at the same time as the slot is added to
+ * @queue.
*
* @irq_lock is an irq-safe spinlock protecting the INTMASK register
* to allow the interrupt handler to modify it directly. Held for only long
* enough to read-modify-write INTMASK and no other locks are grabbed when
* holding this one.
*
- * The @mrq field of struct dw_mci_slot is also protected by @lock,
- * and must always be written at the same time as the slot is added to
- * @queue.
- *
* @pending_events and @completed_events are accessed using atomic bit
* operations, so they don't need any locking.
*
@@ -321,8 +319,8 @@ struct dw_mci_board {
#define SDMMC_ENABLE_SHIFT 0x110
#define SDMMC_DATA(x) (x)
/*
-* Registers to support idmac 64-bit address mode
-*/
+ * Registers to support idmac 64-bit address mode
+ */
#define SDMMC_DBADDRL 0x088
#define SDMMC_DBADDRU 0x08c
#define SDMMC_IDSTS64 0x090
@@ -449,7 +447,8 @@ struct dw_mci_board {
(SDMMC_CTRL_RESET | SDMMC_CTRL_FIFO_RESET | SDMMC_CTRL_DMA_RESET)
/* FIFO register access macros. These should not change the data endian-ness
- * as they are written to memory to be dealt with by the upper layers */
+ * as they are written to memory to be dealt with by the upper layers
+ */
#define mci_fifo_readw(__reg) __raw_readw(__reg)
#define mci_fifo_readl(__reg) __raw_readl(__reg)
#define mci_fifo_readq(__reg) __raw_readq(__reg)
--
2.16.1