[PATCH] clk: tegra: fix pllu rate configuration
From: Marcel Ziswiler
Date: Thu Feb 22 2018 - 18:05:23 EST
Turns out latest upstream U-Boot does not configure/enable pllu which
leaves it at some default rate of 500 kHz:
root@apalis-t30:~# cat /sys/kernel/debug/clk/clk_summary | grep pll_u
pll_u 3 3 0 500000 0
Of course this won't quite work leading to the following messages:
[ 6.559593] usb 2-1: new full-speed USB device number 2 using tegra-
ehci
[ 11.759173] usb 2-1: device descriptor read/64, error -110
[ 27.119453] usb 2-1: device descriptor read/64, error -110
[ 27.389217] usb 2-1: new full-speed USB device number 3 using tegra-
ehci
[ 32.559454] usb 2-1: device descriptor read/64, error -110
[ 47.929777] usb 2-1: device descriptor read/64, error -110
[ 48.049658] usb usb2-port1: attempt power cycle
[ 48.759475] usb 2-1: new full-speed USB device number 4 using tegra-
ehci
[ 59.349457] usb 2-1: device not accepting address 4, error -110
[ 59.509449] usb 2-1: new full-speed USB device number 5 using tegra-
ehci
[ 70.069457] usb 2-1: device not accepting address 5, error -110
[ 70.079721] usb usb2-port1: unable to enumerate USB device
Fix this by actually allowing the rate also being set from within
the Linux kernel.
Signed-off-by: Marcel Ziswiler <marcel.ziswiler@xxxxxxxxxxx>
---
drivers/clk/tegra/clk-pll.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/clk/tegra/clk-pll.c b/drivers/clk/tegra/clk-pll.c
index 7c369e21c91c..830d1c87fa7c 100644
--- a/drivers/clk/tegra/clk-pll.c
+++ b/drivers/clk/tegra/clk-pll.c
@@ -1151,6 +1151,8 @@ static const struct clk_ops tegra_clk_pllu_ops = {
.enable = clk_pllu_enable,
.disable = clk_pll_disable,
.recalc_rate = clk_pll_recalc_rate,
+ .round_rate = clk_pll_round_rate,
+ .set_rate = clk_pll_set_rate,
};
static int _pll_fixed_mdiv(struct tegra_clk_pll_params *pll_params,
--
2.14.3