AW: [PATCH v5] Input: add bu21029 touch driver

[Jonas Mark (BT-FIR/ENG1)]

Hello Dmitry,

> Sorry for the delay. Could you please tell me if the patch below (shoudl
> apply on top of your v5 version) works?

The patch applies cleanly and we will give the code a thorough test.

> diff --git a/Documentation/devicetree/bindings/input/touchscreen/bu21029.txt
> b/Documentation/devicetree/bindings/input/touchscreen/bu21029.txt
> index 030a888365dff..1aaa647cc3eaa 100644
> --- a/Documentation/devicetree/bindings/input/touchscreen/bu21029.txt
> +++ b/Documentation/devicetree/bindings/input/touchscreen/bu21029.txt
> @@ -5,13 +5,14 @@ Required properties:
>   - reg                     : i2c device address of the chip (0x40 or 0x41)
>   - interrupt-parent        : the phandle for the gpio controller
>   - interrupts              : (gpio) interrupt to which the chip is connected
> - - reset-gpios             : gpio pin to reset the chip (active low)
>   - rohm,x-plate-ohms       : x-plate resistance in Ohm
> 
>  Optional properties:
> + - reset-gpios             : gpio pin to reset the chip (active low)
>   - touchscreen-size-x      : horizontal resolution of touchscreen (in pixels)
>   - touchscreen-size-y      : vertical resolution of touchscreen (in pixels)
>   - touchscreen-max-pressure: maximum pressure value
> + - vdd-supply              : power supply for the controoler

There is a typo in controller.

Greetings,
Mark

Building Technologies, Panel Software Fire (BT-FIR/ENG1) 
Bosch Sicherheitssysteme GmbH | Postfach 11 11 | 85626 Grasbrunn | GERMANY | www.boschsecurity.com

Sitz: Stuttgart, Registergericht: Amtsgericht Stuttgart HRB 23118 
Aufsichtsratsvorsitzender: Stefan Hartung; Geschäftsführung: Gert van Iperen, Andreas Bartz, Thomas Quante, Bernhard Schuster