Re: [PATCH 1/4] spi: add support for octal I/O data transfer
From: Boris Brezillon
Date: Thu Oct 04 2018 - 05:05:01 EST
Hi Yogesh,
On Thu, 4 Oct 2018 14:18:37 +0530
Yogesh Gaur <yogeshnarayan.gaur@xxxxxxx> wrote:
> Add flags for Octal I/O data transfer
> Required for the SPI controller which can do the data transfer (TX/RX)
> on 8 data lines e.g. NXP FlexSPI controller.
> SPI_TX_OCTAL: transmit with 8 wires
> SPI_RX_OCTAL: receive with 8 wires
>
> Signed-off-by: Yogesh Gaur <yogeshnarayan.gaur@xxxxxxx>
> ---
> drivers/spi/spi.c | 6 ++++++
> include/linux/spi/spi.h | 2 ++
> 2 files changed, 8 insertions(+)
>
> diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
> index ec395a6..80f672f 100644
> --- a/drivers/spi/spi.c
> +++ b/drivers/spi/spi.c
> @@ -1573,6 +1573,9 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi,
> case 4:
> spi->mode |= SPI_TX_QUAD;
> break;
> + case 8:
> + spi->mode |= SPI_TX_OCTAL;
> + break;
> default:
> dev_warn(&ctlr->dev,
> "spi-tx-bus-width %d not supported\n",
> @@ -1591,6 +1594,9 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi,
> case 4:
> spi->mode |= SPI_RX_QUAD;
> break;
> + case 8:
> + spi->mode |= SPI_RX_OCTAL;
> + break;
> default:
> dev_warn(&ctlr->dev,
> "spi-rx-bus-width %d not supported\n",
> diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h
> index a64235e..2d21307 100644
> --- a/include/linux/spi/spi.h
> +++ b/include/linux/spi/spi.h
> @@ -163,6 +163,8 @@ struct spi_device {
> #define SPI_TX_QUAD 0x200 /* transmit with 4 wires */
> #define SPI_RX_DUAL 0x400 /* receive with 2 wires */
> #define SPI_RX_QUAD 0x800 /* receive with 4 wires */
> +#define SPI_TX_OCTAL 0x1000 /* transmit with 8 wires */
> +#define SPI_RX_OCTAL 0x2000 /* receive with 8 wires */
> int irq;
> void *controller_state;
> void *controller_data;
You're still not updating spi-mem.c to check those flags and
SPI_MEM_MAX_BUSWIDTH is not updated to match the new limit (8 instead
of 4).
Regards,
Boris