[PATCH v2 06/17] thermal: brcmstb: enable+check sensor after its setup is finished

[Bartlomiej Zolnierkiewicz]

Enable+check sensor after setting priv->thermal.

Cc: Markus Mayer <mmayer@xxxxxxxxxxxx>
Cc: bcm-kernel-feedback-list@xxxxxxxxxxxx
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@xxxxxxxxxxx>
---
 drivers/thermal/broadcom/brcmstb_thermal.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/thermal/broadcom/brcmstb_thermal.c b/drivers/thermal/broadcom/brcmstb_thermal.c
index 3511ce6..5650a6a 100644
--- a/drivers/thermal/broadcom/brcmstb_thermal.c
+++ b/drivers/thermal/broadcom/brcmstb_thermal.c
@@ -336,11 +336,11 @@ static int brcmstb_thermal_probe(struct platform_device *pdev)
 		return ret;
 	}
 
+	priv->thermal = thermal;
+
 	thermal_zone_set_mode(thermal, THERMAL_DEVICE_ENABLED);
 	thermal_zone_device_check(thermal);
 
-	priv->thermal = thermal;
-
 	irq = platform_get_irq(pdev, 0);
 	if (irq < 0) {
 		dev_err(&pdev->dev, "could not get IRQ\n");
-- 
1.9.1