[PATCH v2 07/17] thermal: hisi_thermal: enable+check sensor after its setup is finished

[Bartlomiej Zolnierkiewicz]

* Enable+check sensor after checking ntrips and doing chipset specific
  enable operation.

* Remove superfluous second sensor enable+check attempt.

Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@xxxxxxxxxxx>
---
 drivers/thermal/hisi_thermal.c | 9 +++------
 1 file changed, 3 insertions(+), 6 deletions(-)

diff --git a/drivers/thermal/hisi_thermal.c b/drivers/thermal/hisi_thermal.c
index cc4e2ca..370696c 100644
--- a/drivers/thermal/hisi_thermal.c
+++ b/drivers/thermal/hisi_thermal.c
@@ -488,9 +488,6 @@ static int hisi_thermal_register_sensor(struct platform_device *pdev,
 		return ret;
 	}
 
-	thermal_zone_set_mode(sensor->tzd, THERMAL_DEVICE_ENABLED);
-	thermal_zone_device_check(sensor->tzd);
-
 	trip = of_thermal_get_trip_points(sensor->tzd);
 
 	for (i = 0; i < of_thermal_get_ntrips(sensor->tzd); i++) {
@@ -553,6 +550,9 @@ static int hisi_thermal_probe(struct platform_device *pdev)
 		return ret;
 	}
 
+	thermal_zone_set_mode((&data->sensor)->tzd, THERMAL_DEVICE_ENABLED);
+	thermal_zone_device_check((&data->sensor)->tzd);
+
 	if (data->irq) {
 		ret = devm_request_threaded_irq(dev, data->irq, NULL,
 				hisi_thermal_alarm_irq_thread,
@@ -563,9 +563,6 @@ static int hisi_thermal_probe(struct platform_device *pdev)
 		}
 	}
 
-	thermal_zone_set_mode((&data->sensor)->tzd, THERMAL_DEVICE_ENABLED);
-	thermal_zone_device_check((&data->sensor)->tzd);
-
 	return 0;
 }
 
-- 
1.9.1