[PATCH v2 08/17] thermal: qcom: tsens: enable+check sensor after its setup is finished

[Bartlomiej Zolnierkiewicz]

Enable+check sensor after setting tmdev->sensor[i].tzd and calling
chipset specific enable operation.

Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@xxxxxxxxxxx>
---
 drivers/thermal/qcom/tsens.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/thermal/qcom/tsens.c b/drivers/thermal/qcom/tsens.c
index dbd2556..01bff96 100644
--- a/drivers/thermal/qcom/tsens.c
+++ b/drivers/thermal/qcom/tsens.c
@@ -105,13 +105,13 @@ static int tsens_register(struct tsens_device *tmdev)
 		if (IS_ERR(tzd))
 			continue;
 
-		thermal_zone_set_mode(tzd, THERMAL_DEVICE_ENABLED);
-		thermal_zone_device_check(tzd);
-
 		tmdev->sensor[i].tzd = tzd;
 
 		if (tmdev->ops->enable)
 			tmdev->ops->enable(tmdev, i);
+
+		thermal_zone_set_mode(tzd, THERMAL_DEVICE_ENABLED);
+		thermal_zone_device_check(tzd);
 	}
 	return 0;
 }
-- 
1.9.1