Re: [PATCH v2 0/2] phy: cadence: Add driver and dt-bindings for Sierra PHY

[Kishon Vijay Abraham I]

Hi Alan,

On 31/10/18 10:03 PM, Alan Douglas wrote:
> The Cadence Sierra PHY supports a number of different protocols.  This
> series adds a driver with support for USB3 and PCIe modes.
> 
> Only one clock frequency is currently supported, so the value of clock
> provided in device tree is ignored.
> 
> Changes since v1:
> * Moved subnode resets into each subnode in devicetree bindings
> * Modified driver to put subnode resets on exit
> * Changed driver filename to phy-cdns-sierra.c
> 
> Changes since RFC v2:
> * Devicetree bindings modified as suggested by Rob Herring.
> * Tidy up and correction of return paths in probe function.
> 
> Changes since RFC v1:
> * Each group of lanes is now treated as a subnode, and a generic PHY
>   device is created for each group.
> * General cleanup based on comments
> * A reset is now required for each subnode.  The complete PHY block
>   is taken out of reset at initial probe, and remains out of reset.
> * Added a binding to allow for hardware configuration of PHY registers

It's not applying to my -next. Can you rebase this series to -rc1?

Thanks
Kishon
> 
> 
> Alan Douglas (2):
>   dt-bindings: phy: Document cadence Sierra PHY bindings
>   phy: cadence: Add driver for Sierra PHY
> 
>  .../devicetree/bindings/phy/cdns-sierra-phy.txt    |  68 ++++
>  drivers/phy/Kconfig                                |   1 +
>  drivers/phy/Makefile                               |   1 +
>  drivers/phy/cadence/Kconfig                        |   9 +
>  drivers/phy/cadence/Makefile                       |   2 +
>  drivers/phy/cadence/phy-cdns-sierra.c              | 395 +++++++++++++++++++++
>  6 files changed, 476 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/phy/cdns-sierra-phy.txt
>  create mode 100644 drivers/phy/cadence/Kconfig
>  create mode 100644 drivers/phy/cadence/Makefile
>  create mode 100644 drivers/phy/cadence/phy-cdns-sierra.c
>