Re: [PATCH 1/3] dt-bindings: mmc: Add DTS property to disable DCMDs on Arasan controllers

[Heiko Stuebner]

Am Freitag, 1. März 2019, 17:43:45 CET schrieb Christoph Muellner:
> Direct commands (DCMDs) are an optional feature of eMMC 5.1's command
> queue engine (CQE). The Arasan eMMC 5.1 controller uses the CQHCI,
> which exposes a control register bit to enable the feature.
> The current implementation sets this bit unconditionally.
> 
> This patch allows to surpress the feature activation,
> by specifying the property disable-cqe-dcmd.
> 
> Signed-off-by: Christoph Muellner <christoph.muellner@xxxxxxxxxxxxxxxxxxxxx>
> Signed-off-by: Philipp Tomsich <philipp.tomsich@xxxxxxxxxxxxxxxxxxxxx>

Patch subject is needs improvement :-) .
I did scratch my head a lot regarding "where is the code change"
until I actually looked into the patch itself, so you probably want

	mmc: sdhci-of-arasan: Add DTS property to disable DCMDs

or similar instead of "dt-bindings: ..." here to match the subsystem.


Heiko

> ---
>  drivers/mmc/host/sdhci-of-arasan.c | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/mmc/host/sdhci-of-arasan.c b/drivers/mmc/host/sdhci-of-arasan.c
> index c9e3e050ccc8..88dc3f00a5be 100644
> --- a/drivers/mmc/host/sdhci-of-arasan.c
> +++ b/drivers/mmc/host/sdhci-of-arasan.c
> @@ -832,7 +832,10 @@ static int sdhci_arasan_probe(struct platform_device *pdev)
>  		host->mmc_host_ops.start_signal_voltage_switch =
>  					sdhci_arasan_voltage_switch;
>  		sdhci_arasan->has_cqe = true;
> -		host->mmc->caps2 |= MMC_CAP2_CQE | MMC_CAP2_CQE_DCMD;
> +		host->mmc->caps2 |= MMC_CAP2_CQE;
> +
> +		if (!of_property_read_bool(np, "disable-cqe-dcmd"))
> +			host->mmc->caps2 |= MMC_CAP2_CQE_DCMD;
>  	}
>  
>  	ret = sdhci_arasan_add_host(sdhci_arasan);
>