Re: [PATCH v2 1/2] dt-bindings: mtd: brcmnand: Make nand-ecc-strength and nand-ecc-step-size optional
From: Schrempf Frieder
Date: Tue May 21 2019 - 05:33:39 EST
Hi Kamal,
On 20.05.19 21:05, Kamal Dasu wrote:
> nand-ecc-strength and nand-ecc-step-size can be made optional as
> brcmnand driver can support using raw NAND layer detected values.
>
> Signed-off-by: Kamal Dasu <kdasu.kdev@xxxxxxxxx>
> ---
> Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> index bcda1df..29feaba 100644
> --- a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> +++ b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> @@ -101,10 +101,10 @@ Required properties:
> number (e.g., 0, 1, 2, etc.)
> - #address-cells : see partition.txt
> - #size-cells : see partition.txt
> -- nand-ecc-strength : see nand.txt
> -- nand-ecc-step-size : must be 512 or 1024. See nand.txt
>
> Optional properties:
> +- nand-ecc-strength : see nand.txt
> +- nand-ecc-step-size : must be 512 or 1024. See nand.txt
> - nand-on-flash-bbt : boolean, to enable the on-flash BBT for this
> chip-select. See nand.txt
> - brcm,nand-oob-sector-size : integer, to denote the spare area sector size
I think you also need to change all references to nand.txt. This file
was recently moved to nand-controller.yaml.
Regards,
Frieder