Re: [PATCH v2 1/2] dt-bindings: mtd: brcmnand: Make nand-ecc-strength and nand-ecc-step-size optional
From: Miquel Raynal
Date: Tue May 21 2019 - 05:34:56 EST
Schrempf Frieder <frieder.schrempf@xxxxxxxxxx> wrote on Tue, 21 May
2019 09:31:04 +0000:
> Hi Kamal,
>
> On 20.05.19 21:05, Kamal Dasu wrote:
> > nand-ecc-strength and nand-ecc-step-size can be made optional as
> > brcmnand driver can support using raw NAND layer detected values.
> >
> > Signed-off-by: Kamal Dasu <kdasu.kdev@xxxxxxxxx>
> > ---
> > Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt | 4 ++--
> > 1 file changed, 2 insertions(+), 2 deletions(-)
> >
> > diff --git a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> > index bcda1df..29feaba 100644
> > --- a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> > +++ b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> > @@ -101,10 +101,10 @@ Required properties:
> > number (e.g., 0, 1, 2, etc.)
> > - #address-cells : see partition.txt
> > - #size-cells : see partition.txt
> > -- nand-ecc-strength : see nand.txt
> > -- nand-ecc-step-size : must be 512 or 1024. See nand.txt
> >
> > Optional properties:
> > +- nand-ecc-strength : see nand.txt
> > +- nand-ecc-step-size : must be 512 or 1024. See nand.txt
> > - nand-on-flash-bbt : boolean, to enable the on-flash BBT for this
> > chip-select. See nand.txt
> > - brcm,nand-oob-sector-size : integer, to denote the spare area sector size
>
> I think you also need to change all references to nand.txt. This file
> was recently moved to nand-controller.yaml.
>
Oops, completely forgot about that *again*. Thanks for pointing it
Frieder!
MiquÃl