Re: [PATCH 04/14] pwm: meson: change MISC_CLK_SEL_WIDTH to MISC_CLK_SEL_MASK

[Martin Blumenstingl]

Hi Neil,

On Mon, May 27, 2019 at 2:26 PM Neil Armstrong <narmstrong@xxxxxxxxxxxx> wrote:
>
> On 25/05/2019 20:11, Martin Blumenstingl wrote:
> > MISC_CLK_SEL_WIDTH is only used in one place where it's converted into
> > a bit-mask. Rename and change the macro to be a bit-mask so that
> > conversion is not needed anymore. No functional changes intended.
> >
> > Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
> > ---
> >  drivers/pwm/pwm-meson.c | 4 ++--
> >  1 file changed, 2 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/pwm/pwm-meson.c b/drivers/pwm/pwm-meson.c
> > index c62a3ac924d0..84b28ba0f903 100644
> > --- a/drivers/pwm/pwm-meson.c
> > +++ b/drivers/pwm/pwm-meson.c
> > @@ -33,7 +33,7 @@
> >  #define MISC_A_CLK_DIV_SHIFT 8
> >  #define MISC_B_CLK_SEL_SHIFT 6
> >  #define MISC_A_CLK_SEL_SHIFT 4
> > -#define MISC_CLK_SEL_WIDTH   2
> > +#define MISC_CLK_SEL_MASK    0x3
>
> NIT I would have used GENMASK here
that was my initial idea but I decided against it.
the variant I came up with was: #define MISC_CLK_SEL_MASK    GENMASK(1, 0)

however, the actual offset is either 4 or 6 (depending on the PWM channel)
and I felt that duplicating the macro would just make it more complicated
so instead I chose to be consistent with MISC_CLK_DIV_MASK

Let me know if you would like me to change it (then I prefer to update
MISC_CLK_DIV_MASK as well).


Martin