Re: [PATCH v9 08/15] dt: bindings: lp55xx: Be consistent in the document with LED

[Jacek Anaszewski]

Dan,

On 9/25/19 7:46 PM, Dan Murphy wrote:
> Update the document to be consistent in case when using LED.

s/LED/"LED"/.

> This should be capital throughout the document.
> 
> Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
> ---
>  Documentation/devicetree/bindings/leds/leds-lp55xx.txt | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/leds/leds-lp55xx.txt b/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
> index 1b66a413fb9d..bfe2805c5534 100644
> --- a/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
> +++ b/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
> @@ -1,4 +1,4 @@
> -Binding for TI/National Semiconductor LP55xx Led Drivers
> +Binding for TI/National Semiconductor LP55xx LED Drivers
>  
>  Required properties:
>  - compatible: one of
> @@ -12,8 +12,8 @@ Required properties:
>  - clock-mode: Input clock mode, (0: automode, 1: internal, 2: external)
>  
>  Each child has own specific current settings
> -- led-cur: Current setting at each led channel (mA x10, 0 if led is not connected)
> -- max-cur: Maximun current at each led channel.
> +- led-cur: Current setting at each LED channel (mA x10, 0 if LED is not connected)
> +- max-cur: Maximun current at each LED channel.
>  
>  Optional properties:
>  - enable-gpio: GPIO attached to the chip's enable pin
> 

-- 
Best regards,
Jacek Anaszewski