Re: [PATCH v9 08/15] dt: bindings: lp55xx: Be consistent in the document with LED

[Dan Murphy]

Jacek

On 9/25/19 4:31 PM, Jacek Anaszewski wrote:
> Dan,
>
> On 9/25/19 7:46 PM, Dan Murphy wrote:
> > Update the document to be consistent in case when using LED.
> s/LED/"LED"/.

ACK


> > This should be capital throughout the document.
> >
> > Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
> > ---
> >   Documentation/devicetree/bindings/leds/leds-lp55xx.txt | 6 +++---
> >   1 file changed, 3 insertions(+), 3 deletions(-)
> >
> > diff --git a/Documentation/devicetree/bindings/leds/leds-lp55xx.txt b/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
> > index 1b66a413fb9d..bfe2805c5534 100644
> > --- a/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
> > +++ b/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
> > @@ -1,4 +1,4 @@
> > -Binding for TI/National Semiconductor LP55xx Led Drivers
> > +Binding for TI/National Semiconductor LP55xx LED Drivers
> >   
> >   Required properties:
> >   - compatible: one of
> > @@ -12,8 +12,8 @@ Required properties:
> >   - clock-mode: Input clock mode, (0: automode, 1: internal, 2: external)
> >   
> >   Each child has own specific current settings
> > -- led-cur: Current setting at each led channel (mA x10, 0 if led is not connected)
> > -- max-cur: Maximun current at each led channel.
> > +- led-cur: Current setting at each LED channel (mA x10, 0 if LED is not connected)
> > +- max-cur: Maximun current at each LED channel.
> >   
> >   Optional properties:
> >   - enable-gpio: GPIO attached to the chip's enable pin