Re: [RESEND] ACPI / processor_idle: use dead loop instead of io port access for wait

[Rafael J. Wysocki]

Sorry for the delay.

On Monday, September 9, 2019 9:39:37 AM CEST Yin Fengwei wrote:
> In function acpi_idle_do_entry(), we do an io port access to guarantee
> hardware behavior. But it could trigger unnecessary vmexit for
> virtualization environemnt.

Is this a theoretical problem, or do you actually see it?

If you see it, I'd like to have a pointer to a bug report regarding it
or similar.

> From the comments of this part of code, we could use busy wait instead
> of io port access to guarantee hardware behavior and avoid unnecessary
> vmexit.
> 
> Signed-off-by: Yin Fengwei <fengwei.yin@xxxxxxxxx>
> ---
>  drivers/acpi/processor_idle.c | 33 ++++++++++++++++++++++++++++++---
>  1 file changed, 30 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/acpi/processor_idle.c b/drivers/acpi/processor_idle.c
> index ed56c6d20b08..676553228e8f 100644
> --- a/drivers/acpi/processor_idle.c
> +++ b/drivers/acpi/processor_idle.c
> @@ -55,6 +55,8 @@ struct cpuidle_driver acpi_idle_driver = {
>  };
>  
>  #ifdef CONFIG_ACPI_PROCESSOR_CSTATE
> +static struct timespec64 dummy_delta = {0L, 0L};
> +
>  static
>  DEFINE_PER_CPU(struct acpi_processor_cx * [CPUIDLE_STATE_MAX], acpi_cstate);
>  
> @@ -64,6 +66,18 @@ static int disabled_by_idle_boot_param(void)
>  		boot_option_idle_override == IDLE_HALT;
>  }
>  
> +static void dummy_wait(void)
> +{
> +	struct timespec64 now, target;
> +
> +	ktime_get_real_ts64(&now);
> +	target = timespec64_add(now, dummy_delta);
> +
> +	do {
> +		ktime_get_real_ts64(&now);
> +	} while (timespec64_compare(&now, &target) < 0);
> +}

Why not to use ndelay() instead of this? ->

> +
>  /*
>   * IBM ThinkPad R40e crashes mysteriously when going into C2 or C3.
>   * For now disable this. Probably a bug somewhere else.
> @@ -660,8 +674,12 @@ static void __cpuidle acpi_idle_do_entry(struct acpi_processor_cx *cx)
>  		inb(cx->address);
>  		/* Dummy wait op - must do something useless after P_LVL2 read
>  		   because chipsets cannot guarantee that STPCLK# signal
> -		   gets asserted in time to freeze execution properly. */
> -		inl(acpi_gbl_FADT.xpm_timer_block.address);
> +		   gets asserted in time to freeze execution properly.
> +
> +		   Previously, we do io port access here which could trigger
> +		   unnecessary trap to HV for virtualization env. We use dead
> +		   loop here to avoid the impact to virtualization env. */
> +		dummy_wait();
>  	}
>  }
>  
> @@ -683,7 +701,7 @@ static int acpi_idle_play_dead(struct cpuidle_device *dev, int index)
>  		else if (cx->entry_method == ACPI_CSTATE_SYSTEMIO) {
>  			inb(cx->address);
>  			/* See comment in acpi_idle_do_entry() */
> -			inl(acpi_gbl_FADT.xpm_timer_block.address);
> +			dummy_wait();
>  		} else
>  			return -ENODEV;
>  	}
> @@ -902,6 +920,7 @@ static inline void acpi_processor_cstate_first_run_checks(void)
>  {
>  	acpi_status status;
>  	static int first_run;
> +	struct timespec64 ts0, ts1;
>  
>  	if (first_run)
>  		return;
> @@ -912,6 +931,13 @@ static inline void acpi_processor_cstate_first_run_checks(void)
>  			  max_cstate);
>  	first_run++;
>  
> +	/* profiling the time used for dummy wait op */
> +	ktime_get_real_ts64(&ts0);
> +	inl(acpi_gbl_FADT.xpm_timer_block.address);
> +	ktime_get_real_ts64(&ts1);

-> And simply measure the number of nsecs this takes?

> +
> +	dummy_delta = timespec64_sub(ts1, ts0);
> +
>  	if (acpi_gbl_FADT.cst_control && !nocst) {
>  		status = acpi_os_write_port(acpi_gbl_FADT.smi_command,
>  					    acpi_gbl_FADT.cst_control, 8);
> @@ -920,6 +946,7 @@ static inline void acpi_processor_cstate_first_run_checks(void)
>  					"Notifying BIOS of _CST ability failed"));
>  	}
>  }
> +
>  #else
>  
>  static inline int disabled_by_idle_boot_param(void) { return 0; }
>