Re: [PATCH v6 1/7] thermal: sun8i: add thermal driver for H6/H5/H3/A64/A83T/R40

[OndÅej Jirman]

On Wed, Nov 27, 2019 at 11:48:32AM -0800, Vasily Khoruzhick wrote:
> On Wed, Nov 27, 2019 at 11:44 AM Frank Lee <tiny.windzz@xxxxxxxxx> wrote:
> >
> > Hello Vasily,
> >
> > Thank you very much for your work on this.
> > This looks good to me.
> 
> Thanks!
> 
> > By the way, I would like to ask comments about adding the following code.
> 
> Can we add it as follow up patch? I don't think that I have a device
> with working suspend to test it and I'm hesitant to add any code that
> I can't test.

I have, but it doesn't use any of the clocks and resets, so it wouldn't
test this fully, and basicaly doesn't need re-calibration at all, probably.

So that may be one feedback. On a83t, I'd made these callbacks a no-op.

regards,
	o.

> >
> > diff --git a/drivers/thermal/sun8i_thermal.c b/drivers/thermal/sun8i_thermal.c
> > index c0ed60782b11..579dde5e0701 100644
> > --- a/drivers/thermal/sun8i_thermal.c
> > +++ b/drivers/thermal/sun8i_thermal.c
> > @@ -629,11 +629,63 @@ static const struct of_device_id of_ths_match[] = {
> >  };
> >  MODULE_DEVICE_TABLE(of, of_ths_match);
> >
> > +static int __maybe_unused sun8i_thermal_suspend(struct device *dev)
> > +{
> > + struct ths_device *tmdev; = dev_get_drvdata(dev);
> > +
> > + clk_disable(tmdev->mod_clk);
> > + clk_disable(tmdev->bus_clk);
> > +
> > + reset_control_assert(tmdev->reset);
> > +
> > + return 0;
> > +}
> > +
> > +static int __maybe_unused sun8i_thermal_resume(struct device *dev)
> > +{
> > + struct ths_device *tmdev; = dev_get_drvdata(dev);
> > + int error;
> > +
> > + error = reset_control_deassert(tmdev->reset);
> > + if (error)
> > + return error;
> > +
> > + error = clk_enable(tmdev->bus_clk);
> > + if (error)
> > + goto assert_reset;
> > +
> > + clk_set_rate(tmdev->mod_clk, 24000000);
> > + error = clk_enable(tmdev->mod_clk);
> > + if (error)
> > + goto bus_disable;
> > +
> > + sun8i_ths_calibrate(tmdev);
> > +
> > + ret = tmdev->chip->init(tmdev);
> > + if (ret)
> > + goto mod_disable;
> > +
> > + return 0;
> > +
> > +mod_disable:
> > + clk_disable(tmdev->mod_clk);
> > +bus_disable:
> > + clk_disable(tmdev->bus_clk);
> > +assert_reset:
> > + reset_control_assert(tmdev->reset);
> > +
> > + return 0;
> > +}
> > +
> > +static SIMPLE_DEV_PM_OPS(sun8i_thermal_pm_ops,
> > + sun8i_thermal_suspend, sun8i_thermal_resume);
> > +
> >  static struct platform_driver ths_driver = {
> >   .probe = sun8i_ths_probe,
> >   .remove = sun8i_ths_remove,
> >   .driver = {
> >   .name = "sun8i-thermal",
> > + .pm = &sun8i_thermal_pm_ops,
> >   .of_match_table = of_ths_match,
> >   },
> >  };
> >
> > Yangtao
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel