Re: [PATCH v2 04/11] soc: pmc: Add blink output clock registration to Tegra PMC

[Dmitry Osipenko]

27.11.2019 07:59, Sowjanya Komatineni ÐÐÑÐÑ:
> Tegra PMC has blink control to output 32 Khz clock out to Tegra
> blink pin. Blink pad DPD state and enable controls are part of
> Tegra PMC register space.
> 
> Currently Tegra clock driver registers blink control by passing
> PMC address and register offset to clk_register_gate which performs
> direct PMC access during clk_ops and with this when PMC is in secure
> mode, any access from non-secure world does not go through.
> 
> This patch adds blink control registration to the Tegra PMC driver
> using PMC specific clock gate operations that use tegra_pmc_readl
> and tegra_pmc_writel to support both secure mode and non-secure
> mode PMC register access.
> 
> Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>
> ---
>  drivers/soc/tegra/pmc.c | 49 +++++++++++++++++++++++++++++++++++++++++++++++++
>  1 file changed, 49 insertions(+)
> 
> diff --git a/drivers/soc/tegra/pmc.c b/drivers/soc/tegra/pmc.c
> index a353f6d0a832..1cfb7797dbd5 100644
> --- a/drivers/soc/tegra/pmc.c
> +++ b/drivers/soc/tegra/pmc.c
> @@ -61,12 +61,15 @@
>  #define  PMC_CNTRL_SYSCLK_OE		BIT(11) /* system clock enable */
>  #define  PMC_CNTRL_SYSCLK_POLARITY	BIT(10) /* sys clk polarity */
>  #define  PMC_CNTRL_PWRREQ_POLARITY	BIT(8)
> +#define  PMC_CNTRL_BLINK_EN		BIT(7)
>  #define  PMC_CNTRL_MAIN_RST		BIT(4)
>  
>  #define PMC_WAKE_MASK			0x0c
>  #define PMC_WAKE_LEVEL			0x10
>  #define PMC_WAKE_STATUS			0x14
>  #define PMC_SW_WAKE_STATUS		0x18
> +#define PMC_DPD_PADS_ORIDE		0x1c
> +#define  PMC_DPD_PADS_ORIDE_BLINK	BIT(20)
>  
>  #define DPD_SAMPLE			0x020
>  #define  DPD_SAMPLE_ENABLE		BIT(0)
> @@ -79,6 +82,7 @@
>  
>  #define PWRGATE_STATUS			0x38
>  
> +#define TEGRA210_PMC_BLINK_TIMER	0x40

This register is common for all Tegra SoCs, therefore TEGRA210_ prefix
isn't needed.