Re: [PATCH v2] bluetooth: hci_bcm: enable IRQ capability from node

[Kevin Hilman]

Guillaume La Roque <glaroque@xxxxxxxxxxxx> writes:

> Actually IRQ can be found from GPIO but all platorms don't support

nit: s/platorms/platforms/

> gpiod_to_irq, it's the case on amlogic chip.
> so to have possibility to use interrupt mode we need to add interrupts
> field in node and support it in driver.
>
> Signed-off-by: Guillaume La Roque <glaroque@xxxxxxxxxxxx>
> ---
> sorry for noise,
>
> v2 is for rebasing on master branch
>
> guillaume
>
>  drivers/bluetooth/hci_bcm.c | 3 +++
>  1 file changed, 3 insertions(+)
>
> diff --git a/drivers/bluetooth/hci_bcm.c b/drivers/bluetooth/hci_bcm.c
> index f8f5c593a05c..9f52d57c56de 100644
> --- a/drivers/bluetooth/hci_bcm.c
> +++ b/drivers/bluetooth/hci_bcm.c
> @@ -1409,6 +1409,7 @@ static int bcm_serdev_probe(struct serdev_device *serdev)
>  {
>  	struct bcm_device *bcmdev;
>  	const struct bcm_device_data *data;
> +	struct platform_device *pdev;
>  	int err;
>  
>  	bcmdev = devm_kzalloc(&serdev->dev, sizeof(*bcmdev), GFP_KERNEL);
> @@ -1421,6 +1422,8 @@ static int bcm_serdev_probe(struct serdev_device *serdev)
>  #endif
>  	bcmdev->serdev_hu.serdev = serdev;
>  	serdev_device_set_drvdata(serdev, bcmdev);
> +	pdev = to_platform_device(bcmdev->dev);
> +	bcmdev->irq = platform_get_irq(pdev, 0);

I don't know this driver well enough to be sure, but don't you need some
error checking here?

If this fails (on platforms with no IRQ defined), is an error code in
bcmdev->irq going to affect later code that tries to setup IRQs?

Kevin