Re: [PATCH v2] bluetooth: hci_bcm: enable IRQ capability from node

[guillaume La Roque]

hi Kevin,


On 12/6/19 1:58 AM, Kevin Hilman wrote:
> Guillaume La Roque <glaroque@xxxxxxxxxxxx> writes:
>
>> Actually IRQ can be found from GPIO but all platorms don't support
> nit: s/platorms/platforms/
will fix in v3
>> gpiod_to_irq, it's the case on amlogic chip.
>> so to have possibility to use interrupt mode we need to add interrupts
>> field in node and support it in driver.
>>
>> Signed-off-by: Guillaume La Roque <glaroque@xxxxxxxxxxxx>
>> ---
>> sorry for noise,
>>
>> v2 is for rebasing on master branch
>>
>> guillaume
>>
>>  drivers/bluetooth/hci_bcm.c | 3 +++
>>  1 file changed, 3 insertions(+)
>>
>> diff --git a/drivers/bluetooth/hci_bcm.c b/drivers/bluetooth/hci_bcm.c
>> index f8f5c593a05c..9f52d57c56de 100644
>> --- a/drivers/bluetooth/hci_bcm.c
>> +++ b/drivers/bluetooth/hci_bcm.c
>> @@ -1409,6 +1409,7 @@ static int bcm_serdev_probe(struct serdev_device *serdev)
>>  {
>>  	struct bcm_device *bcmdev;
>>  	const struct bcm_device_data *data;
>> +	struct platform_device *pdev;
>>  	int err;
>>  
>>  	bcmdev = devm_kzalloc(&serdev->dev, sizeof(*bcmdev), GFP_KERNEL);
>> @@ -1421,6 +1422,8 @@ static int bcm_serdev_probe(struct serdev_device *serdev)
>>  #endif
>>  	bcmdev->serdev_hu.serdev = serdev;
>>  	serdev_device_set_drvdata(serdev, bcmdev);
>> +	pdev = to_platform_device(bcmdev->dev);
>> +	bcmdev->irq = platform_get_irq(pdev, 0);
> I don't know this driver well enough to be sure, but don't you need some
> error checking here?
>
> If this fails (on platforms with no IRQ defined), is an error code in
> bcmdev->irq going to affect later code that tries to setup IRQs?

not needed to do something here because bcm_get_resources function check irq <=0 if yes it check if host-wakeup gpio was defined in node and try a gpiod_to_irq.

at the end in bcm_request_irq function i check if irq <=0 if yes return EOPNOTSUPP


> Kevin
>

Guillaume