Re: [PATCH 3/3] USB: Disable LPM on WD19's Realtek Hub during setting its ports to U0

[Alan Stern]

On Mon, 6 Jan 2020, Kai-Heng Feng wrote:

> > On Jan 5, 2020, at 00:20, Alan Stern <stern@xxxxxxxxxxxxxxxxxxx> wrote:
> > 
> > On Sat, 4 Jan 2020, Kai-Heng Feng wrote:
> > 
> >>>>>> @@ -3533,9 +3533,17 @@ int usb_port_resume(struct usb_device *udev, pm_message_t msg)
> >>>>>> 	}
> >>>>>> 
> >>>>>> 	/* see 7.1.7.7; affects power usage, but not budgeting */
> >>>>>> -	if (hub_is_superspeed(hub->hdev))
> >>>>>> +	if (hub_is_superspeed(hub->hdev)) {
> >>>>>> +		if (hub->hdev->quirks & USB_QUIRK_DISABLE_LPM_ON_U0) {
> >>>>>> +			usb_lock_device(hub->hdev);
> >>>>>> +			usb_unlocked_disable_lpm(hub->hdev);
> >>>>>> +		}
> >>>>>> 		status = hub_set_port_link_state(hub, port1, USB_SS_PORT_LS_U0);
> >>>>>> -	else
> >>>>>> +		if (hub->hdev->quirks & USB_QUIRK_DISABLE_LPM_ON_U0) {
> >>>>>> +			usb_unlocked_enable_lpm(hub->hdev);
> >>>>>> +			usb_unlock_device(hub->hdev);
> >>>>> 
> >>>>> The locking here seems questionable.  Doesn't this code sometimes get
> >>>>> called with the hub already locked?  Or with the child device locked
> >>>>> (in which case locking the hub would violate the normal locking order:  
> >>>>> parent first, child second)?
> >>> 
> >>> I did a little checking.  In many cases the child device _will_ be 
> >>> locked at this point.
> >>> 
> >>>> Maybe introduce a new lock? The lock however will only be used by this specific hub.
> >>>> But I still want the LPM can be enabled for this hub.
> >>> 
> >>> Do you really need to lock the hub at all?  What would the lock protect 
> >>> against?
> >> 
> >> There can be multiple usb_port_resume() run at the same time for different ports, so this is to prevent LPM enable/disable race.
> > 
> > But there can't really be an LPM enable/disable race, can there?  The 
> > individual function calls are protected by the bandwidth mutex taken by 
> > the usb_unlocked_{en|dis}able_lpm routines, and the overall LPM setting 
> > is controlled by the hub device's lpm_disable_counter.
> 
> For enable/disable LPM itself, there's no race.
> But the lock here is to protect hub_set_port_link_state().
> If we don't lock the hub, other instances of usb_port_resume()
> routine can enable LPM and we want the LPM stays disabled until
> hub_set_port_link_state() is done.

That's what I was trying to explain above.  Other instances of 
usb_port_resume() _can't_ enable LPM while this instance is running, 
because the lpm_disable_counter value will be > 0.

Alan Stern