Re: [PATCH v2] iio: imu/mpu6050: support dual-edge IRQ

[Jonathan Cameron]

On Sat, 11 Jan 2020 16:07:35 +0100
MichaÅ MirosÅaw <mirq-linux@xxxxxxxxxxxx> wrote:

> On Sat, Jan 11, 2020 at 12:10:47PM +0000, Jonathan Cameron wrote:
> > On Mon, 06 Jan 2020 12:17:54 +0100
> > MichaÅ MirosÅaw <mirq-linux@xxxxxxxxxxxx> wrote:
> >   
> > > Make mpu6050 usable on platforms which provide only any-edge interrupts.
> > > This also covers shared interrupt case.  
> > 
> > So this had me confused for a bit because I assumed we were trying to make
> > a level interrupt providing device work with edge interrupts.  Seems
> > device supports a pulsed  mode and the driver supports this.
> > 
> > Why do we want to detect on both edges?  Do you have a crazy board
> > with this shared and some devices using the rising edge and some the falling one?
> > 
> > For shared case it should return that it did not handle the interrupt
> > to allow spurious interrupt detection to work...  
> 
> Hmm. The shared interrupt is a red herring. I'll remove the sentence
> from commitmsg as it looks like the driver needs a few more fixups
> to be able to share the interrupt line.
> 
> The patch is required on platforms that support only dual-edge
> interrupts, like eg. AT91SAM9G45-based one I have.

Yikes. That's a new one to me.  You have my sympathies.
Hmm. Normally I'd just call that a broken platform and ignore
it but I suppose this change isn't too harmful.

I'll aim to pick up v2, with the adjusted message.  If you haven't
done it yet, state the example platform as well.

Thanks,

Jonathan

> 
> Best Regards,
> MichaÅ MirosÅaw