Re: [RFC PATCH v1] driver core: Set fw_devlink to "permissive" behavior by default

[Greg Kroah-Hartman]

On Fri, Mar 27, 2020 at 11:25:48AM +0100, Marek Szyprowski wrote:
> Hi,
> 
> On 2020-03-21 22:03, Saravana Kannan wrote:
> > Set fw_devlink to "permissive" behavior by default so that device links
> > are automatically created (with DL_FLAG_SYNC_STATE_ONLY) by scanning the
> > firmware.
> >
> > This ensures suppliers get their sync_state() calls only after all their
> > consumers have probed successfully. Without this, suppliers will get
> > their sync_state() calls at late_initcall_sync() even if their consuer
> >
> > Ideally, we'd want to set fw_devlink to "on" or "rpm" by default. But
> > that needs more testing as it's known to break some corner case
> > drivers/platforms.
> >
> > Cc: Rob Herring <robh+dt@xxxxxxxxxx>
> > Cc: Frank Rowand <frowand.list@xxxxxxxxx>
> > Cc: devicetree@xxxxxxxxxxxxxxx
> > Signed-off-by: Saravana Kannan <saravanak@xxxxxxxxxx>
> 
> This patch has just landed in linux-next 20200326. Sadly it breaks 
> booting of the Raspberry Pi3b and Pi4 boards, either in 32bit or 64bit 
> mode. There is no warning nor panic message, just a silent freeze. The 
> last message shown on the earlycon is:
> 
> [    0.893217] Serial: 8250/16550 driver, 1 ports, IRQ sharing enabled

Ugh, not good.

Saravana, mind if I revert this?

thanks,

greg k-h