Re: [PATCH net-next 2/9] dt-bindings: net: add backplane dt bindings

[Russell King - ARM Linux admin]

On Fri, Mar 27, 2020 at 02:04:11AM +0100, Andrew Lunn wrote:
> On Thu, Mar 26, 2020 at 03:51:15PM +0200, Florinel Iordache wrote:
> > Add ethernet backplane device tree bindings
> 
> > +  - |
> > +    /* Backplane configurations for specific setup */
> > +    &mdio9 {
> > +        bpphy6: ethernet-phy@0 {
> > +            compatible = "ethernet-phy-ieee802.3-c45";
> > +            reg = <0x0>;
> > +            lane-handle = <&lane_d>; /* use lane D */
> > +            eq-algorithm = "bee";
> > +            /* 10G Short cables setup: up to 30 cm cable */
> > +            eq-init = <0x2 0x5 0x29>;
> > +            eq-params = <0>;
> > +        };
> > +    };
> 
> So you are modelling this as just another PHY? Does the driver get
> loaded based on the PHY ID in registers 2 and 3? Does the standard
> define these IDs or are they vendor specific?

We likely need some mutual coordination here between the patches I've
already posted for PCS support and these patches.

As I've said, we can't deal with multiple ethernet PHYs connected to
one MAC, the patches I've posted cope with that, but likely will need
changes for this.  Conversely, these patches will need changes for my
work.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 10.2Mbps down 587kbps up