Re: [PATCH net-next 4/4] net: phy: bcm54140: add cable diagnostics support

[Florian Fainelli]

On 5/9/2020 3:37 PM, Michael Walle wrote:
> Use the generic cable tester functions from bcm-phy-lib to add cable
> tester support.
> 
> 100m cable, A/B/C/D open:
>   Cable test started for device eth0.
>   Cable test completed for device eth0.
>   Pair: Pair A, result: Open Circuit
>   Pair: Pair B, result: Open Circuit
>   Pair: Pair C, result: Open Circuit
>   Pair: Pair D, result: Open Circuit
>   Pair: Pair A, fault length: 106.60m
>   Pair: Pair B, fault length: 103.32m
>   Pair: Pair C, fault length: 104.96m
>   Pair: Pair D, fault length: 106.60m
> 
> 1m cable, A/B connected, pair C shorted, D open:
>   Cable test started for device eth0.
>   Cable test completed for device eth0.
>   Pair: Pair A, result: OK
>   Pair: Pair B, result: OK
>   Pair: Pair C, result: Short within Pair
>   Pair: Pair D, result: Open Circuit
>   Pair: Pair C, fault length: 0.82m
>   Pair: Pair D, fault length: 1.64m
> 
> 1m cable, A/B connected, pair C shorted with D:
>   Cable test started for device eth0.
>   Cable test completed for device eth0.
>   Pair: Pair A, result: OK
>   Pair: Pair B, result: OK
>   Pair: Pair C, result: Short to another pair
>   Pair: Pair D, result: Short to another pair
>   Pair: Pair C, fault length: 1.64m
>   Pair: Pair D, fault length: 1.64m
> 
> The granularity of the length measurement seems to be 82cm.
> 
> Signed-off-by: Michael Walle <michael@xxxxxxxx>

Reviewed-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
-- 
Florian