Re: [PATCH V6 3/3] dt-bindings: serial: Add binding for UART pin swap

[Akash Asthana]

Hi Rob,

On 5/15/2020 8:31 AM, Rob Herring wrote:
> On Thu, May 07, 2020 at 08:30:47PM +0530, Akash Asthana wrote:
> > Add documentation to support RX-TX & CTS-RTS GPIO pin swap in HW.
> >
> > Signed-off-by: Akash Asthana <akashast@xxxxxxxxxxxxxx>
> > ---
> >   Documentation/devicetree/bindings/serial/serial.yaml | 6 ++++++
> >   1 file changed, 6 insertions(+)
> >
> > diff --git a/Documentation/devicetree/bindings/serial/serial.yaml b/Documentation/devicetree/bindings/serial/serial.yaml
> > index 53204d9..e657dd6 100644
> > --- a/Documentation/devicetree/bindings/serial/serial.yaml
> > +++ b/Documentation/devicetree/bindings/serial/serial.yaml
> > @@ -67,6 +67,12 @@ properties:
> >         (wired and enabled by pinmux configuration).  This depends on both the
> >         UART hardware and the board wiring.
> >   
> > +  rx-tx-swap:
> > +    description: RX and TX pins are swapped.
> > +
> > +  cts-rts-swap:
> > +    description: CTS and RTS pins are swapped.
> Need 'type: boolean' on both of these.

okay, will correct in next version

Regards,

Akash

> > +
> >   if:
> >     required:
> >       - uart-has-rtscts
> > --
> > The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,\na Linux Foundation Collaborative Project

--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,\na Linux Foundation Collaborative Project