[PATCH 07/13] ARM: dts: exynos: Override thermal by label in Exynos5250

[Krzysztof Kozlowski]

Using full paths to extend or override a device tree node is error prone
since if there was a typo error, a new node will be created instead of
extending the node as it was desired.  This will lead to run-time errors
that could be hard to detect.

A mistyped label on the other hand, will cause a dtc compile error
(during build time).

Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx>
---
 arch/arm/boot/dts/exynos5250.dtsi | 38 +++++++++++++++----------------
 1 file changed, 18 insertions(+), 20 deletions(-)

diff --git a/arch/arm/boot/dts/exynos5250.dtsi b/arch/arm/boot/dts/exynos5250.dtsi
index 0249d16e187f..488d3f9fab59 100644
--- a/arch/arm/boot/dts/exynos5250.dtsi
+++ b/arch/arm/boot/dts/exynos5250.dtsi
@@ -1085,26 +1085,6 @@
 		};
 	};
 
-	thermal-zones {
-		cpu_thermal: cpu-thermal {
-			polling-delay-passive = <0>;
-			polling-delay = <0>;
-			thermal-sensors = <&tmu 0>;
-
-			cooling-maps {
-				map0 {
-				     /* Corresponds to 800MHz at freq_table */
-				     cooling-device = <&cpu0 9 9>, <&cpu1 9 9>;
-				};
-				map1 {
-				     /* Corresponds to 200MHz at freq_table */
-				     cooling-device = <&cpu0 15 15>,
-						      <&cpu1 15 15>;
-			       };
-		       };
-		};
-	};
-
 	timer {
 		compatible = "arm,armv7-timer";
 		interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
@@ -1120,6 +1100,24 @@
 	};
 };
 
+&cpu_thermal {
+	polling-delay-passive = <0>;
+	polling-delay = <0>;
+	thermal-sensors = <&tmu 0>;
+
+	cooling-maps {
+		map0 {
+			/* Corresponds to 800MHz at freq_table */
+			cooling-device = <&cpu0 9 9>, <&cpu1 9 9>;
+		};
+		map1 {
+			/* Corresponds to 200MHz at freq_table */
+			cooling-device = <&cpu0 15 15>,
+					 <&cpu1 15 15>;
+		};
+	};
+};
+
 &dp {
 	power-domains = <&pd_disp1>;
 	clocks = <&clock CLK_DP>;
-- 
2.17.1