Re: [PATCH net-next + leds v2 6/7] net: phy: marvell: add support for LEDs controlled by Marvell PHYs

[Marek Behun]

On Thu, 10 Sep 2020 19:34:35 +0100
Russell King - ARM Linux admin <linux@xxxxxxxxxxxxxxx> wrote:

> On Thu, Sep 10, 2020 at 08:31:54PM +0200, Andrew Lunn wrote:
> > Generally the driver will default to the hardware reset blink
> > pattern. There are a few PHY drivers which change this at probe, but
> > not many. The silicon defaults are pretty good.  
> 
> The "right" blink pattern can be a matter of how the hardware is
> wired.  For example, if you have bi-colour LEDs and the PHY supports
> special bi-colour mixing modes.
> 

Have you seen such, Russell? This could be achieved via the multicolor
LED framework, but I don't have a device which uses such LEDs, so I
did not write support for this in the Marvell PHY driver.

(I guess I could test it though, since on my device LED0 and LED1
are used, and this to can be put into bi-colour LED mode.)