Re: [PATCH RFC v2 4/4] Documentation: Change doc for split_lock_detect parameter

From: Fenghua Yu
Date: Fri Oct 30 2020 - 15:42:41 EST


Hi, Randy,

On Wed, Oct 28, 2020 at 10:14:20PM -0700, Randy Dunlap wrote:
> On 10/28/20 1:28 PM, Fenghua Yu wrote:
> > Since #DB for bus lock detect changes the split_lock_detect parameter,
> > update the documentation for the changes.
> >
> > Signed-off-by: Fenghua Yu <fenghua.yu@xxxxxxxxx>
> > Reviewed-by: Tony Luck <tony.luck@xxxxxxxxx>
> > ---
> > .../admin-guide/kernel-parameters.txt | 47 +++++++++++++++----
> > 1 file changed, 39 insertions(+), 8 deletions(-)
> >
> > diff --git a/Documentation/admin-guide/kernel-parameters.txt b/Documentation/admin-guide/kernel-parameters.txt
> > index 526d65d8573a..51312484c2b6 100644
> > --- a/Documentation/admin-guide/kernel-parameters.txt
> > +++ b/Documentation/admin-guide/kernel-parameters.txt
> > @@ -5044,27 +5044,58 @@
> > spia_peddr=
> >
> > split_lock_detect=
> > - [X86] Enable split lock detection
> > + [X86] Enable split lock detection or bus lock detection
> >
> > When enabled (and if hardware support is present), atomic
> > instructions that access data across cache line
> > - boundaries will result in an alignment check exception.
> > + boundaries will result in an alignment check exception
> > + for split lock detection or an debug exception for
> > + bus lock detection.
> >
> > off - not enabled
> >
> > - warn - the kernel will emit rate limited warnings
> > - about applications triggering the #AC
> > - exception. This mode is the default on CPUs
> > - that supports split lock detection.
> > + warn - Default mode.
> >
> > - fatal - the kernel will send SIGBUS to applications
> > - that trigger the #AC exception.
> > + If split lock detection is enabled in
> > + hardware, the kernel will emit rate limited
> > + warnings about applications triggering the #AC
> > + exception.
> > +
> > + If bus lock detection is enabled in hardware,
> > + the kernel will emit rate limited warnings
> > + about applications triggering the #DB
> > + exception.
> > +
> > + Default behavior is from bus lock detection
> > + if both features are enabled in hardware.
> > +
> > + fatal - If split lock detection is enabled in
> > + hardware, the kernel will send SIGBUS to
> > + applications that trigger the #AC exception.
> > +
> > + If bus lock detection is enabled in hardware,
> > + the kernel will send SIGBUS to application
> > + that trigger the #DB exception.
> > +
> > + Default behavior is from split lock detection
> > + if both are enabled in hardware.
> > +
>
> Hi,
> This appears to have quite a bit of duplicated lines....

Ok. I will simplify this paragraph.

Thank you very much for your review!

-Fenghua