Re: [PATCH 6/9] ARM: dts: sun8i-v3s: Add the V3s NMI IRQ controller

[Maxime Ripard]

On Mon, Nov 02, 2020 at 11:25:22AM +0100, Paul Kocialkowski wrote:
> Hi,
> 
> On Mon 02 Nov 20, 11:12, Maxime Ripard wrote:
> > On Sat, Oct 31, 2020 at 07:21:34PM +0100, Paul Kocialkowski wrote:
> > > The V3s/V3 has a NMI interrupt controller, mainly used for the AXP209.
> > > Its address follows the sytsem controller block, which was previously
> > > incorrectly described as spanning over 0x1000 address bytes.
> > 
> > Is it after, or right in the middle of it?
> 
> That's up for interpretation actually:
> - The V3 datasheet mentions that System Control is 0x01C00000 --- 0x01C00FFF;
> - In practice, sunxi_sram.c uses a regmap with max_reg set to 0x30 for the
>   V3s/H3 so this gives us some room.
> 
> Looking at other SoCs with the same setup (take sun8i-r40 for instance),
> system-control is limited to 0x30 and the NMI controller follows it.
> In the case of R40, the SRAM controlled is also said to be 4K-long in the
> Allwinner docs.
> 
> So all in all, this leads me to believe that the system-controller instance
> stops well before 0x1c000d0 on the V3s as well. Otherwise, we should also
> make the R40 consistent.

That's a bit unfortunate, but yeah, I guess we want to remain consistent here.

Maxime

Attachment: signature.asc
Description: PGP signature