Re: [PATCH v4 4/4] clk: sifive: Fix the wrong bit field shift

[Zong Li]

On Sat, Nov 21, 2020 at 9:29 AM Palmer Dabbelt <palmer@xxxxxxxxxxx> wrote:
>
> On Wed, 11 Nov 2020 02:06:08 PST (-0800), zong.li@xxxxxxxxxx wrote:
> > The clk enable bit should be 31 instead of 24.
> >
> > Signed-off-by: Zong Li <zong.li@xxxxxxxxxx>
> > Reported-by: Pragnesh Patel <pragnesh.patel@xxxxxxxxxx>
> > ---
> >  drivers/clk/sifive/sifive-prci.h | 4 ++--
> >  1 file changed, 2 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/clk/sifive/sifive-prci.h b/drivers/clk/sifive/sifive-prci.h
> > index 802fc8fb9c09..da7be9103d4d 100644
> > --- a/drivers/clk/sifive/sifive-prci.h
> > +++ b/drivers/clk/sifive/sifive-prci.h
> > @@ -59,7 +59,7 @@
> >
> >  /* DDRPLLCFG1 */
> >  #define PRCI_DDRPLLCFG1_OFFSET               0x10
> > -#define PRCI_DDRPLLCFG1_CKE_SHIFT    24
> > +#define PRCI_DDRPLLCFG1_CKE_SHIFT    31
> >  #define PRCI_DDRPLLCFG1_CKE_MASK     (0x1 << PRCI_DDRPLLCFG1_CKE_SHIFT)
> >
> >  /* GEMGXLPLLCFG0 */
> > @@ -81,7 +81,7 @@
> >
> >  /* GEMGXLPLLCFG1 */
> >  #define PRCI_GEMGXLPLLCFG1_OFFSET    0x20
> > -#define RCI_GEMGXLPLLCFG1_CKE_SHIFT  24
> > +#define RCI_GEMGXLPLLCFG1_CKE_SHIFT  31
> >  #define PRCI_GEMGXLPLLCFG1_CKE_MASK  (0x1 << PRCI_GEMGXLPLLCFG1_CKE_SHIFT)
> >
> >  /* CORECLKSEL */
>
> Section 7.3 of v1.0 of the FU540 manual says that bit 24 contains the PLL clock
> enable for both of these.  I don't know if that's accurate, but if it is then I
> believe this would break the FU540.  Don't have one to test on, though.

Yes, the manual seems to be wrong and should be corrected. It doesn't
break the FU540 yet because we don't use these fields in s-mode Linux
driver, we set them in m-mode FSBL/U-boot-SPL bootloader during boot
time, and the implementation of FSBL and U-boot-SPL both are correct.
The following link is the U-boot SPL source:

https://github.com/u-boot/u-boot/blob/da09b99ea572cec9a114872e480b798db11f9c6e/drivers/clk/sifive/fu540-prci.c#L128