Re: [PATCH] bcache: consider the fragmentation when update the writeback rate

[Dongsheng Yang]

在 2020/11/3 星期二 下午 8:42, Dongdong Tao 写道:
> From: dongdong tao <dongdong.tao@xxxxxxxxxxxxx>
>
> Current way to calculate the writeback rate only considered the
> dirty sectors, this usually works fine when the fragmentation
> is not high, but it will give us unreasonable small rate when
> we are under a situation that very few dirty sectors consumed
> a lot dirty buckets. In some case, the dirty bucekts can reached
> to CUTOFF_WRITEBACK_SYNC while the dirty data(sectors) noteven
> reached the writeback_percent, the writeback rate will still
> be the minimum value (4k), thus it will cause all the writes to be
> stucked in a non-writeback mode because of the slow writeback.
>
> This patch will try to accelerate the writeback rate when the
> fragmentation is high. It calculate the propotional_scaled value
> based on below:
> (dirty_sectors / writeback_rate_p_term_inverse) * fragment
> As we can see, the higher fragmentation will result a larger
> proportional_scaled value, thus cause a larger writeback rate.
> The fragment value is calculated based on below:
> (dirty_buckets *  bucket_size) / dirty_sectors
> If you think about it, the value of fragment will be always
> inside [1, bucket_size].
>
> This patch only considers the fragmentation when the number of
> dirty_buckets reached to a dirty threshold(configurable by
> writeback_fragment_percent, default is 50), so bcache will
> remain the original behaviour before the dirty buckets reached
> the threshold.
>
> Signed-off-by: dongdong tao <dongdong.tao@xxxxxxxxxxxxx>
> ---
>   drivers/md/bcache/bcache.h    |  1 +
>   drivers/md/bcache/sysfs.c     |  6 ++++++
>   drivers/md/bcache/writeback.c | 21 +++++++++++++++++++++
>   3 files changed, 28 insertions(+)
>
> diff --git a/drivers/md/bcache/bcache.h b/drivers/md/bcache/bcache.h
> index 1d57f48307e6..87632f7032b6 100644
> --- a/drivers/md/bcache/bcache.h
> +++ b/drivers/md/bcache/bcache.h
> @@ -374,6 +374,7 @@ struct cached_dev {
>   	unsigned int		writeback_metadata:1;
>   	unsigned int		writeback_running:1;
>   	unsigned char		writeback_percent;
> +	unsigned char		writeback_fragment_percent;
>   	unsigned int		writeback_delay;
>   
>   	uint64_t		writeback_rate_target;
> diff --git a/drivers/md/bcache/sysfs.c b/drivers/md/bcache/sysfs.c
> index 554e3afc9b68..69499113aef8 100644
> --- a/drivers/md/bcache/sysfs.c
> +++ b/drivers/md/bcache/sysfs.c
> @@ -115,6 +115,7 @@ rw_attribute(stop_when_cache_set_failed);
>   rw_attribute(writeback_metadata);
>   rw_attribute(writeback_running);
>   rw_attribute(writeback_percent);
> +rw_attribute(writeback_fragment_percent);


Hi Dongdong and Coly,

    What is the status about this patch? In my opinion, it is a problem 
we need to solve,

but can we just reuse the parameter of writeback_percent, rather than 
introduce a new writeback_fragment_percent?

That means the semantic of writeback_percent will act on dirty data 
percent and dirty bucket percent.

When we found there are dirty buckets more than (c->nbuckets * 
writeback_percent), start the writeback.


Thanx

Yang

>   rw_attribute(writeback_delay);
>   rw_attribute(writeback_rate);
>   
> @@ -197,6 +198,7 @@ SHOW(__bch_cached_dev)
>   	var_printf(writeback_running,	"%i");
>   	var_print(writeback_delay);
>   	var_print(writeback_percent);
> +	var_print(writeback_fragment_percent);
>   	sysfs_hprint(writeback_rate,
>   		     wb ? atomic_long_read(&dc->writeback_rate.rate) << 9 : 0);
>   	sysfs_printf(io_errors,		"%i", atomic_read(&dc->io_errors));
> @@ -308,6 +310,9 @@ STORE(__cached_dev)
>   	sysfs_strtoul_clamp(writeback_percent, dc->writeback_percent,
>   			    0, bch_cutoff_writeback);
>   
> +	sysfs_strtoul_clamp(writeback_fragment_percent, dc->writeback_fragment_percent,
> +			    0, bch_cutoff_writeback_sync);
> +
>   	if (attr == &sysfs_writeback_rate) {
>   		ssize_t ret;
>   		long int v = atomic_long_read(&dc->writeback_rate.rate);
> @@ -498,6 +503,7 @@ static struct attribute *bch_cached_dev_files[] = {
>   	&sysfs_writeback_running,
>   	&sysfs_writeback_delay,
>   	&sysfs_writeback_percent,
> +	&sysfs_writeback_fragment_percent,
>   	&sysfs_writeback_rate,
>   	&sysfs_writeback_rate_update_seconds,
>   	&sysfs_writeback_rate_i_term_inverse,
> diff --git a/drivers/md/bcache/writeback.c b/drivers/md/bcache/writeback.c
> index 3c74996978da..34babc89fdf3 100644
> --- a/drivers/md/bcache/writeback.c
> +++ b/drivers/md/bcache/writeback.c
> @@ -88,6 +88,26 @@ static void __update_writeback_rate(struct cached_dev *dc)
>   	int64_t integral_scaled;
>   	uint32_t new_rate;
>   
> +	/*
> +	 * We need to consider the number of dirty buckets as well
> +	 * when calculating the proportional_scaled, Otherwise we might
> +	 * have an unreasonable small writeback rate at a highly fragmented situation
> +	 * when very few dirty sectors consumed a lot dirty buckets, the
> +	 * worst case is when dirty_data reached writeback_percent and
> +	 * dirty buckets reached to cutoff_writeback_sync, but the rate
> +	 * still will be at the minimum value, which will cause the write
> +	 * stuck at a non-writeback mode.
> +	 */
> +	struct cache_set *c = dc->disk.c;
> +
> +	if (c->gc_stats.in_use > dc->writeback_fragment_percent && dirty > 0) {
> +		int64_t dirty_buckets = (c->gc_stats.in_use * c->nbuckets) / 100;
> +		int64_t fragment = (dirty_buckets *  c->cache->sb.bucket_size) / dirty;
> +
> +		proportional_scaled =
> +		div_s64(dirty, dc->writeback_rate_p_term_inverse) * (fragment);
> +	}
> +
>   	if ((error < 0 && dc->writeback_rate_integral > 0) ||
>   	    (error > 0 && time_before64(local_clock(),
>   			 dc->writeback_rate.next + NSEC_PER_MSEC))) {
> @@ -969,6 +989,7 @@ void bch_cached_dev_writeback_init(struct cached_dev *dc)
>   	dc->writeback_metadata		= true;
>   	dc->writeback_running		= false;
>   	dc->writeback_percent		= 10;
> +	dc->writeback_fragment_percent	= 50;
>   	dc->writeback_delay		= 30;
>   	atomic_long_set(&dc->writeback_rate.rate, 1024);
>   	dc->writeback_rate_minimum	= 8;