Re: [PATCH v2] leds: apu: extend support for PC Engines APU1 with newer firmware
From: Enrico Weigelt, metux IT consult
Date: Wed Feb 17 2021 - 06:08:05 EST
On 16.02.21 14:30, Andreas Eberlein wrote:
Hi,
The DMI_PRODUCT_NAME entry on current firmware of PC Engines APU1 changed
from "APU" to "apu1"
This modification adds the missing DMI data and thereby the LED support for
the PC Engines APU1 with firmware versions >= 4.6.8.
Do you have a device for more intensive testing ?
In that case I'd like to suggest splitting the driver into gpio and
gpio-based LED (using leds-gpio) - just like already I did for apu2/3/4.
Maybe this even could also be moveed into the apu2 driver. This probably
just makes sense if there're more gpio-connected devices than just LED)
Personally, I don't have access to the old apu1 board (IIRC not even
produced anymore for several years), so I didn't dare to touch anything
here.
Note that apu1 vs. apu2/3/4 have completely different SOC with different
gpio logic - that was one of the reasons for writing a completely new
driver for apu2+ from scrath, rather than extending the old one.
--- a/drivers/leds/leds-apu.c
+++ b/drivers/leds/leds-apu.c
@@ -83,6 +83,7 @@ static const struct apu_led_profile apu1_led_profile[] = {
};
static const struct dmi_system_id apu_led_dmi_table[] __initconst = {
+ /* PC Engines APU with factory bios "SageBios_PCEngines_APU-45" */
{
.ident = "apu",
.matches = {
@@ -90,6 +91,14 @@ static const struct dmi_system_id apu_led_dmi_table[] __initconst = {
DMI_MATCH(DMI_PRODUCT_NAME, "APU")
}
},
+ /* PC Engines APU with "Mainline" bios >= 4.6.8 */
+ {
+ .ident = "apu",
+ .matches = {
+ DMI_MATCH(DMI_SYS_VENDOR, "PC Engines"),
+ DMI_MATCH(DMI_PRODUCT_NAME, "apu1")
+ }
+ },
{}
};
MODULE_DEVICE_TABLE(dmi, apu_led_dmi_table);
@@ -173,7 +182,7 @@ static int __init apu_led_init(void)
int err;
if (!(dmi_match(DMI_SYS_VENDOR, "PC Engines") &&
- dmi_match(DMI_PRODUCT_NAME, "APU"))) {
+ (dmi_match(DMI_PRODUCT_NAME, "APU") || dmi_match(DMI_PRODUCT_NAME, "apu1")))) {
pr_err("No PC Engines APUv1 board detected. For APUv2,3 support, enable CONFIG_PCENGINES_APU2\n");
return -ENODEV;
}
Looks good to me. But don't dare giving official ack, since I don't
have an apu1 board for testing.
Is Alan Mizrahi (original author) still here ?
--mtx
--
---
Hinweis: unverschlüsselte E-Mails können leicht abgehört und manipuliert
werden ! Für eine vertrauliche Kommunikation senden Sie bitte ihren
GPG/PGP-Schlüssel zu.
---
Enrico Weigelt, metux IT consult
Free software and Linux embedded engineering
info@xxxxxxxxx -- +49-151-27565287