Re: [PATCH v2 0/2] MCAN: Add support for implementing transceiver as a phy

[Aswath Govindraju]

Hi all,

On 15/04/21 9:16 pm, Aswath Govindraju wrote:
> The following series of patches add support for implementing the
> transceiver as a phy of m_can_platform driver.
> 
> TCAN1042 has a standby signal that needs to be pulled high for
> sending/receiving messages[1]. TCAN1043 has a enable signal along with
> standby signal that needs to be pulled up for sending/receiving
> messages[2], and other combinations of the two lines can be used to put the
> transceiver in different states to reduce power consumption. On boards
> like the AM654-idk and J721e-evm these signals are controlled using gpios.
> 
> These gpios are set in phy driver, and the transceiver can be put in
> different states using phy API. The phy driver is added in the series [3].
> 
> This patch series is dependent on [4].
> 
> Changes since v1:
> - Used the API devm_phy_get_optional() instead of 
>   devm_of_phy_get_optional_by_index()
> 
> [1] - https://www.ti.com/lit/ds/symlink/tcan1042h.pdf
> [2] - https://www.ti.com/lit/ds/symlink/tcan1043-q1.pdf
> [3] - https://lore.kernel.org/patchwork/project/lkml/list/?series=495365
> [4] - https://lore.kernel.org/patchwork/patch/1413286/
> 

Posted v3 for this series.

Thanks,
Aswath

> Faiz Abbas (2):
>   dt-bindings: net: can: Document transceiver implementation as phy
>   can: m_can: Add support for transceiver as phy
> 
>  .../devicetree/bindings/net/can/bosch,m_can.yaml    |  3 +++
>  drivers/net/can/m_can/m_can.c                       | 10 ++++++++++
>  drivers/net/can/m_can/m_can.h                       |  2 ++
>  drivers/net/can/m_can/m_can_platform.c              | 13 +++++++++++++
>  4 files changed, 28 insertions(+)
>